My 02 freelander 1.8 petrol just tuns over but won't start

2001 2003 LAND ROVER FREELANDER SERVICE MANUAL
just download the service manual and all your queries will be solved :)

Land Rover Freelander 2002-2005 KV6 Timming belt and ...

? 4:31
https://www.youtube.com/watch?v=sz_oe9tIFH4
Jul 3, 2011 - Uploaded by Jaime Depaula
Land Rover Freelander 2002-2005 KV6 Timming belt andreplacing valves - Video 2 ... shops in North Eastern USA for bent valves and timing belt change? .... Land Rover 200tdiTiming Belt -From Broken Belt to Retiming the ...

ROVER K Series Cambelt Change Video - YouTube

? 10:52
https://www.youtube.com/watch?v=1Qn8ljQKZxA
May 4, 2012 - Uploaded by metalworker007
How to change a rover K series cam belt .. by Technozen of ...soy espa?ol porfavor quiero saber timing marks de MG ROVER 25 petrol 1795cc engen .... Hi, Have a Land Rover Freelander1999 petrol serie K, that dont start, ...

Freelander 1.8i timing belt - Land Rover Technical Archive - LR4x4 ...

forums.lr4x4.com > ... > Tech Archive > Land Rover Technical Archive

Nov 20, 2006 - 1 post - ‎1 author
The following is instructions for replacing the timing (or camshaft) belt on the 1.8i petrol engine, as fitted to a Freelander. This is the K-series ... With the timing set, thecam sprocket marks should look like this. Posted Image

How to Replace timing belt on Land Rover Freelander 2.5 ...

have had this before with more than one make of vehicle and it often turns out to be the immobilisor _BUT _ check the temeprature sensor first before doing anything as it may not be working so you are trying to start without any choke ,try a starter spray and if fires up first time then at least you know what it is ,as i cannot advise exactly where it is as engine not stated but i do have a handbook for a rover 400 ,yes i know its a car but the engine is the same unless its a american market vehicle with cheap petrol and monster engines thats not in our models

hi seems to be a commom problem crank shalf sensor
have it tested be for parts are purchased-im sure-its css
price around$146.

Replace CPS (Crankshaft positioning switch) Very common Rover problem and many times will not throw a fault code.

your auto advance should not have changed with a plug wire replacement. double check to be absolutely sure you've got all the wires routed correctly

Hi,
Judging by the problem you have a 1.8 petrol engine?,if it is they used to over fuel on start up ,you can try changing the engine coolant temp sensor as this is the usual cause ,if not then some more info on the vehicle would be usefull.

Could be simple thing like a plug, had a sservice recently???
However these engines are very very common for head gasket failure, check fluids, i.e, coolant look for oil contamination, and oil check for water etc, check plugs for wear and corrosion.

Good luck Davelee

It does sound like electrical problems. When it does this you need to know is it not getting fire, fuel or both. The alarm could be a problem, engine control, or a simple ground strap loose. Make sure you battery terminals are clean and connections are tight. The last time i saw this happen it turned out to be a wiring issue because someone had tapped into the factory alarm harness and the wiring was done very poorly which was causing the problem.

it's a starter motor problem, the solenoid contact inside the starter
is dirty give it a good cleanup with a sand paper and it should be fine. I have the same starting problem, I just cleanup the copper contacts and presto! starts in one click. or you can buy a starter
copper contact from under $12 from ebayUK go to freelander starter motor.