SQUARE KEY STUCK IN THE IGNITION

1-
My ignition key will not turn to off. I can remove the key, but it stays in the accessory mode. What's the fix?
My ignition key will not turn to off can remove the key but it stays in...

2.
Ignition key is stuck and does not turn Inspection Service & Cost
Ignition key is stuck and does not turn Inspection Service Cost...

3.
Ignition key won turn

Sounds like you have an electrical short under or inside the dashboard somewhere.
PLEASE do not turn the radio on again until that is fixed.
As a retired firefighter, I can honestly tell you, you might start a fire and burn up your car if you do not fix this.
Be blessed.

Look for a 30Amp square fuse in the fuse box under hood, pull that fuse and the key will come out, how ever with out the fuse you may not be able to shift from park. Ignition lock has to be replaced.

u need to replace the ignition lock cylinder

try some grafite if not your keys are not cut like the original. key grafite

the ignition lock cylinder exploded in the housing and thats why the key is stuck,there is a little square panel under the steering column pop that off and push on the white knob and that will let the key turn and hopefully come out,,and then all ok,but you still need a new switch

check the ground bar under the carpet by the drivers door sill it is probably corroded

Is the column round or square? I think 1993 is round. Sounds like the ignition lock cylinder needs replaced.

This truck has a switch in the shifter assembly that tells the ignition the truck is in Park or not. If the shifter doesn't hit that switch right this can happen. Also, there is a component in the ignition (a solenoid) that allows the key to be released if the Park switch is pushed. To be sure it's one of these two things, try this.... Get the key stuck, then disconnect the battery. If the key comes right out, it's either the switch or the solenoid. Good luck!

This is a VERY common problem and there is a campaign though I am not sure it ever made it to full recall. The ultimate answer is to have the ignition switch replaced. In the meantime, you'll need to be able to get that key out. On the bottom side of the steering column there is a one inch square rubber plug that you pry out. You can then use your pointer finger to push the switch in. This will release the lock and let you turn your key to the off position and remove. You may want to leave this plug out as you'll be doing this a lot until it is repaired.