05 Saturn vue torque spec for the pressure plate I been told its 15 ft. lbs. is that right
SOURCE: I NEED THE TORQUE SPECS.
They are probably 8mm bolts and 17- 20 seems to be where they would be
SOURCE: 2005 SATURN VUE ABS, AWD, R/FRONT BEARING REPLACEMENT
just did one today. removed housing from car, and used a press . be careful of aluminum housing. also used penatrating spray. clean oxidation from inside bearing hole,then lubricating, helped in installation
SOURCE: 87 samurai bolt torque specs for engine
The haynes book is not recommended since there are numerous mistakes and they still will not update. One of the biggest is the firing order.
The factory service manual is the only way to go.
Head bolts - 46 - 50.5 lbs (there is an order sequence for the bolts)
Intake & exhuast manifolds- 13.5 - 20 lbs
Flywheel - 41.5 - 47 lbs
Clutch cover - 13.5 - 20 lbs
SOURCE: i need the torque specs for a ford 300 inline 6
Tighten all bolts to 10 Lbs, then 20 Lbs, then 35 Lbs.
That should be fine for the 6 cylinder flywheel.
SOURCE: head bolt torque specs 01
You have to make sure you get new bolts because the bolts are torque to yield if you don't you will have major problems later.
First Pass - 63 N·m or 46 lb ft
Final Pass - 90 degrees To achieve this you must have a torque angle gauge you can buy this a auto-zone for 12.99
598 views
Usually answered in minutes!
×