I have a 2002 ford taurus ses i replaced the fuel pump, fuel driver module, fuel pressure regulator and its still dropping fuel pressure. why is that?

SOURCE: Fuel Pump in 2002 Ford Taurus

in the gas tank hope it help fixya our post

SOURCE: Where is the fuel pressure regulator located on an 2002 f150 v6?

in the center of the motor,in the rear on the fuel rail

Greg Bernett

• 2993 Answers
• Posted on Jul 04, 2009

SOURCE: 2002 ford taurus wtaer pump

Removal & Installation 3.0L (2V) To Remove:

1. Drain the engine cooling system.
2. Loosen the water pump pulley.
3. Remove the bolt and the nut and position the roll restrictor bracket out of the way.
4. Remove the accessory drive belt.
5. Remove the generator.
6. Remove the bolt and the accessory drive belt tensioner.
7. Remove the nut, the bolt and the support bracket.
8. Remove the bolts and the water pump pulley.
9. Disconnect the water pump inlet hose and the crankshaft position sensor electrical connector.
10. Remove the bolts and the water pump, and clean the sealing surfaces

1. Install the water pump. Tighten bolts in the sequence shown:
1. Tighten numbers 1-7 to 18 ft.-lbs. (25 Nm)
2. Tighten numbers 8-12 to 89 in.-lbs. (10 Nm)
3. Connect the crankshaft position sensor electrical connector and the water pump inlet hose
4. Install the support bracket.
5. Install the accessory drive shaft tensioner.
6. Install the generator.
7. Install the roll restrictor bracket, bolt and the nut.
8. Install the water pump pulley.
9. Install the accessory drive belt.
10. Connect the battery ground cable.
11. Fill the engine cooling system.

Marvin

• 85242 Answers
• Posted on Nov 13, 2009

SOURCE: Where is the fuse for the fuel pump. Not the reset

these are located in the underhood fuse box
Position #16 20A* Fuel Pump Relay
position #30 fuel pump relay fuse.

Quinn Texada

• 93 Answers
• Posted on Jan 23, 2010

SOURCE: where is the fuel pump relay on the 95 ford taurus

Hello , fuel pump relay location is in the relay box by the radiator. The fuel psi regulator is on the fuel rail itself. The regulator looks like a small disk about 1.5inchs in dia. It will have a vacuum line running to it.

Quinn