The van was running great then it slowed to 10 MOH and the SES Light, SLIP Light, and the TCS OFF Light all came on. We made it home, the next day I tried to start the van and it won't start. I had the codes read and came up with P0605, and not the diag link is not even working. Someone told me there might be a fuse for the link that might have blown and needs to be replaced but I still can not get the van to run.
SOURCE: TCS/SLIP & Check Engine Light Warning
TCS is Traction Control System,and all TCS's are controlled though the Anti Lock Braking (ABS) system.Here's how it works:Each wheel,or in some cases,only the drive wheels have a speed sensor mounted near the hub or axle,and sends a speed signal to the PCM (Powertrain Control Module).The PCM monitors wheel speed continuously,and if it sees a speed out of the ordinary,say for example the right rear tire is spinning and traveling at a much higher speed than the left rear,the PCM will pulse the brakes through the ABS system on the right rear to slow down the right rear so that the left and right wheel speeds match up,this is how the traction control works.So,if you have a TCS problem,the PCM will see this and set a Dignostic Trouble Code (DTC).You need to pull the DTC's out of the system with a scan tool,diagnose and repair the DTC's.It could likely be something as simple as a malfunctioning wheel speed sensor,but you won't know until the codes are pulled out,as this will point in the general direction.Good luck.
SOURCE: p1320 trouble code plus
The P1320 code is essentially a coil primary voltage problem. This is traceable using a labscope or accurate DVOM and perhaps you can isolate one or two coils that still work but are close to failure...but there is a nissan service message recommending replacement of ALL coils with updated/improved models to prevent this type of failure. TCS/SLIP is traction control. Most likely you have a speed sensor issue. Be aware, some vehicles can falsely illuminate TCS because of low tire pressure in a single wheel.
Testimonial: "thanks needed a point in the right direction"
SOURCE: TCS/SLIP/Service engine Light
Sounds like your quest is stuck in fail safe mode, most likely could be a problem with your electronic throttle body.
SOURCE: service engine soon, TCS off, SLIP
The oil change wouldn't cause this problem. Just in-case, check the engine oil level.
There are many emission sensors in the car that will make the engine light come ON. Best way to find out what's going on is to have an auto-parts store hook up a engine code reader and tell you what the code means. Most auto-part store will do this for free.
Testimonial: "very helpful. i have the mechanic checked the car , the sensor says it has a malfunction in P0340"
SOURCE: nissan vanette 2.3d wont start
air lock ,slacken injector pipes ,crank engine and as fuel starts to appear tighten pipes as fuel appears .make sure you prime the injector pump first .great workhorses these motors
Testimonial: "Thankyou ,thought that might be the problem , just didnt know how to fix it."
287 views
Usually answered in minutes!
×