My Toyota sienna van shakes when accelerating at any speeds between 35-70mph. Dealer said axle needed to be replaced. My dad keeps talking about cv joints. Is it normal to replace the axle but not the cv joints?
SOURCE: CV joint replacement
Generally no tool is required. If you use a "pickle fork" you will risk damaging the dust boot.
Have you tried whacking the spindle right near where the ball joint stud comes through? This will take a few good shots to break it loose.
Be careful not to hit the threads!
SOURCE: CV Joint Axle Replacement
It's not an easy job, and a very messy one! If you have never done CV's before, I suggest you take it to a CV specialist, as they will do it quickly and cheaply in comparison to the hardship you will have to go through doing it yourself. These vehicles are common for the axles rusting into the hubs and siezing in there, and often the whole hub needs to be removed and the axle heated and pressed out. The new CV's often don't come with a tone wheel for the ABS system and you may need to swap the old tone wheel onto the new CV joint, and measure the alignment of it with the sensor when refitting.
SOURCE: 2008 Toyota Sienna
I have the same issue with my 2008 Sienna CE. Dealer has checked TSB's and computer for any updates. Says there is none...
SOURCE: average repair cost for cv joint or axle replacement
Average time should be around 2-3 hours. Every shop charges different hourly rates. Dealerships will be around at least 80 an hour, smaller shops will run lower.
SOURCE: 97 toyota celica outer cv boot replacement passenger side
have you undone the main hub bolt, if yes, there could be two different items holding the cv joint on, one is a small circlip in the joint end, or the other is just like an expanding metal ring again only small. what i had to do to change my one was take the driveshaft out (easier to see whats there) then gently (rubber hammer) hit the CV joint it should then fall off to allow you to change the CV joint. I spent over an hour trying to get the metal ring off, then after taking driveshaft off it was changed and back on in ten mins. Or you can go to a motor factors or similar and get a boot puller, my opinion hammer works better lol
524 views
Usually answered in minutes!
×