Remove fuel pump 1994 ford explore - 1994 Ford Explorer Limited

SOURCE: replace the fuel pump/fuel filter and I suspect a bad pump,truck will not start, and the inert.. switch is in down postion??

changed fuel pump car doesn't wanna start

SOURCE: how do i remove the fuel pump from a 1994 ford

Lift the carpet in the back of the vehicle to see if the is a access panel to the fuel tank, to access the fuel gauge.If no access panel then have to drop the fuel tank.

SOURCE: how to remove the fuel pump from a ford explorer

Removing the fuel pump requires lowering the fuel tank from the vehicle, the fuel lines require special tools to remove the lines from the pump without damaging the lines( tool availiable at parts store) then remove the lock ring by turning counter clockwise , then the pump , is held to the bottom of the tank by a clip on each side of the pump once depressed the pump will come out.

Duane Wong

• 6826 Answers
• Posted on Jul 31, 2010

SOURCE: how to replace ford explorer fuel pump

REMOVAL & INSTALLATION NOTE: To gain access to the fuel pump, it is necessary to remove the fuel tank.

1. Depressurize the fuel system and remove the fuel tank from the vehicle.
2. Remove any dirt that has accumulated around the fuel pump attaching flange, to prevent it from entering the tank during service.
3. Turn the fuel pump locking ring counterclockwise using a locking ring removal tool and remove the locking ring.
4. Remove the fuel pump and bracket assembly.
5. Remove the seal gasket and discard it. To install:
   
6. Put a light coating of heavy grease on a new seal ring to hold it in place during assembly. Install it in fuel tank ring groove. Fig. 1: Fuel pump and sending unit used on the Regular Cab Ranger pick-up
   Fig. 2: Fuel pump and sending unit used on the Super Cab Ranger pick-up
   Fig. 3: Fuel pump and sending unit used on the Explorer and Mountaineer
   
   
7. Insert the fuel pump assembly into the fuel tank, then secure it in place with the locking ring. Tighten the ring until secure.
8. Install the tank in the vehicle.
9. Install a minimum of 10 gallons of fuel and check for leaks.
10. Install a pressure gauge on the throttle body valve and turn the ignition ON for 3 seconds. Turn the key OFF, then repeat the key cycle five to ten times until the pressure gauge shows at least 30 psi. Reinspect for leaks at the fittings.
11. Remove the pressure gauge. Start the engine and check for fuel leaks.

Jeremy W.

• 5332 Answers
• Posted on Feb 21, 2012

SOURCE: 1994 ford explorer, new fuel pump,new fuel pump relay,no power to fuel pump

Have you checked the fuel ppm cut off switch? It should be under the passenger side of the dash. Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Instant Repair Help over the Phone

6ya.com

Save Time & Money by instantly connecting to...