I removed the intake to replace spark plugs and valve cover gaskets. The van was running OK before I started work. After reassembling when I start the van the RPM goes to about 4000 and than comes back down to about 3500 RPM. I have check for air leaks. I believe that I reinstalled all of the lines correctly but now am unsure. I check all of the connections I disconnected and all locks which I did hear. Suggestions?
SOURCE: 2006 pt cruiser idles high with no pcv valve hose connected
Replace the PVC valve, it's probably clogged.
SOURCE: How do I remove the air filter on a 1996 Chrysler
there should be a box at the other end of the intake hose with two clamps on it after unclamping it pull the top away from the box then pull up
SOURCE: 2000 chrysler concorde 2.7 timeing went out sat 1
P0171 system lean bank 1. Check for vac leaks at all hoses and at intake maniflod. Check fuel pressure.
SOURCE: 1999 Chrysler Sebring Coupe 2.5 oil in spark plug
It is possible the tubes are leaking at the bottom but highly unlikely. There is next to 0 oil pressure in that area so the tubes would actually drain if leaking. I would start with the tube seals and gaskets as you have already planned and check it again later down the road like at the next oil change interval. You're on the right track for the repair, just be patient with the intake plenum and you'll do fine.
SOURCE: I need to replace the spark plugs on a 2005
you need to remove the intake to replace the front plugs
it's equipted with coil packs so you don't have to replace wires and cap
most of the time you don't need to replace gasket but you can get one just in case.
make sure you put the plugs that the manufacture recomended
52 views
Usually answered in minutes!
×