Cars & Trucks Logo

Related Topics:

d
david Posted on Jan 18, 2014
Answered by a Fixya Expert

Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Mercury sable problems

Changed all sensors drives fine about 10to20 miles then stals restart goes a little farer then stalla again

1 Answer

Vincent G

Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

  • Cars & Trucks Master 2,363 Answers
  • Posted on Jan 20, 2014
Vincent G
Cars & Trucks Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

Superstar:

An expert that got 20 achievements.

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Joined: Jul 09, 2009
Answers
2363
Questions
4
Helped
1032063
Points
5917

Change fuel filter
Check fuel pressure
Use a bottle of yellow HEET dry gas / fuel dryer to remove moisture in your fuel tank.

5 Related Answers

Anonymous

  • 1 Answer
  • Posted on Oct 28, 2008

SOURCE: 2000 Mercury Sable double overhead cam Transmission problem

manual para reparación cadena de tiempo de motor v6 3.0 sable 2000

Ad

Anonymous

  • 1 Answer
  • Posted on Jan 13, 2009

SOURCE: 2003 mercury sable, not idleing right

I was looking under the hood, and noticed that i could hear air rushing around. I found that a vacum hose had decayed and cracked. After i replaced that, everything has been fine

c17hydro

Greg Bernett

  • 2993 Answers
  • Posted on Apr 01, 2009

SOURCE: 2000 mercury sable drive belt

For VIN 2 FLEX Fuel:

4488d47.jpg For VIN U and S....with A/C:

c2b84a7.jpg PLEASE DON'T FORGET TO RATE!!!!

emissionwiz

Marvin

  • 85242 Answers
  • Posted on Apr 15, 2009

SOURCE: 2006 Envoy fuel sensor failure

the sending unit for the gas gauge is in the fuel tank and part of the fule pump module, it is not sold seperately. price around $350.00, 2 hours labor to install the part. see photo
c8ad23d.jpg

zink0326

  • 11 Answers
  • Posted on May 02, 2009

SOURCE: mercury sable 2002 serpentine belt change

There are also two serpentine belt types for the 2002 sable. The S and U type engine. Take the old belt with you the the parts store. As for the diagram, I googled it under images and about a dozen correct ones came up. Remember the 2002 sable is the same as the 2002 Tarus.

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer
0helpful
1answer

My 2003 6 cylinder Mercury Sable had just got up to 40 MPH felt a sudden surge of acceleration. Braked to hol it back from maybe hitting the car in front. At light shifted to park, heard rattling.

you might wanna check the throttle position sensor, or the cable itself. ( Throttle position sensor gets stuck with dirt and debree through time)

Regards!
0helpful
1answer

1999 sable drives fine but occasionally after coming to a stop will not move forward but if you put it in reverse it will go in reverse. If you turn off car and restart it will once again drive fine.

Sounds like an electrical problem, not a mechanical problem, with the transmission. Take it to a transmission shop for diagnosis. Cost to repair should be considerably less than rebuilding the transmission.
1helpful
3answers

2002 Sable sedan choke/missing/sputtering intermittent

The PO 316 is still misfires om first 1000 revolutions
so the shop did a poor job for you on resolveing the
cylinder misfires

Try a diffferent shop

Have to clean the MAF Sensor & replace upstream
oxygen sensors if over 100,000 miles

Need the correct oem spark spark plugs/any brand

No reason the gas filter should be clogged unless it was in
the car for 10 years

Fuel pressure should be checked

Need to check for cylinder misfires on a road test of 20
miles or more with professional software in Mode#06
0helpful
1answer

I have a 2001 mercury sable with a 3.0 dohc engine. When you start the engine it misses and runs rough till it warms up, it then runs fine

Run the codes,change spark plugs,clean the MAF sensor and always make sure to replace a fuel filter every 30K miles. don-ohio
0helpful
1answer

From a stop, when you start to accelerate, the car skip like the transmission is out of sync. Once it starts going it shifts fine. This only happens after the car has warmed up (5-6miles of driving).

Spark Plugs--every 70,000 miles
O2 Sensors -front 2 every 100,000 miles
Clean MAF Sensor
Check coils for misfires
Trans & power steering --Fluid every 30,000 miles
0helpful
1answer

No oil pressure, camshaft position sensor error,

Yes, the sensor is in small housing the goes in the hole where the distributor used to go. That also drives the oil pump so don't drive it you'll ruin the engine. It's located down under the throttle body, near transmission end of the engine.
0helpful
1answer

I have a 2005 Mercury Sable when it shifts into third gear it jerks and a little again into fourth gear. First and second are pretty normal. It has 140,000 miles

Sounds like the band that controls 3rd and forth gear is almost worn out. Have you followed the recomended interval for transmission fluid changes? What does your trans fluid look like?
9helpful
1answer

2000 Mercury Sable double overhead cam Transmission problem

manual para reparación cadena de tiempo de motor v6 3.0 sable 2000
Not finding what you are looking for?

79 views

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29492 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...