Tailights not working

SOURCE: signal lights and brake lights stopped working

the multifunction switch (turn signal switch) is a major cuase of this. your high mount stop lamp wire is run through the switch.

SOURCE: ford expedition yr'00 headlight not working checked fuses..

The low beam headlamps have a seperate fuse for each lamp in the central or underdash fuse panel.
The right headlamp is fuse fuse 26 (10amp) and the left is fuse 28 (10 amp). These fuse are hot only when headlamps are on so you need to test them with a test light with headlamps on. If they do not have power to them then concern is either headlamp switch or daytime running lamp relay if your vehicle is equipped with this feature, or a bad multifunction switch.
Power leaves the headlamp switch on the RD/YE wire and goes to multifunction switch. It leaves multifunction switch on the other RD/YE wire The wire will then go thru either a connector c2003 located behind the passenger side air bag behind the dash or to the DRL relay if your vehicle has this feature and leaves there on RD/BK wire to the headlights .

SOURCE: Turn signals hazards and brake lights are not working fuses good

did u check fuses under the hood on driver side lol yes ford has them thear also

SOURCE: 1999 ford crown vic dash light running light problem.

Check all the bulbs at tail end for parking and brakes, test grounds and harness for trailer. Check fuses. clean batery terminals, Re instal head light swich properly and make sure all wires conect.
Vitally

Testimonial: "thank you for quick response will try all of your suggestions will re post if no luck."

SOURCE: 98 ford lariat. Headlights stopped

Is this both the high beams and low beams that do not work ?

If you checked all 3 fuses with a meter ( with the headlamp in Low position for both low beam fuses or in high for the high beam fuse ), the next items to test are the MFS ( MultiFunction Switch ) and the main headlamp switch ( test not look at it ).

The main headlamp test chart


The test chart for the MFS