At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
Front seat in 1996 Dodge Ram Pickup won't slide forward or back
My front passenger seat in a 1996 Dodge Ram 1500 won't slide. For a while it was difficult to move and now it won't move at all. I'm not aware of any damage to it. Where should I start troubleshooting?
Re: Front seat in 1996 Dodge Ram Pickup won't slide...
1.Make sure the stiff wire that crosses under the seat to the passenger side latch hasn't come off. 2.Soak the slides with some good penatrating oil (NOT WD40!).
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
1998, 1999, 2000, 2001 - Here you will find fuse box diagrams of Dodge Ram Pickup 1500/2500/3500 1994, 1995, 1996, 1997, 1998, 1999, 2000 and 2001, get ...
There's probably something in the way. Get under and behind the seat with a flashlight and check the back end of the rails to see if something is there.
Assembly of converter to trans and then tunit to engine? The torque converter must engage and slide into the front pump. The seal is easily damamaged if not properly fitted.Once the trans is against the engine the converter can be slid forward to bolt the flex plste.There should not be more than approx. 1/4 inch between the converter and trans bell housing if the converter is properly mated to the trans. Good Luck, Ned.
JACK LOCATION
Removal (All Models)
The jack and jack tools are stored under the front
passenger seat. Lift the flap on the side of the seat for
access.
Remove the jack and tools by removing the wing bolt and
sliding the assembly from under the sea
We had our rear facing car seat in the back seat of our car , but when we went camping with our truck we put it in the front seat (center) . Our baby loved that she could sit and still see us.
Our truck was older , so did not have air bags which could be dangerous to the child.
Some newer trucks have a switch to turn off the passenger side air bag.
just remove the nuts on the back side of the hub. the hub will still be firmly in place. you will have to beat either the hub itself or on the bolts from the back to get it loose. they are usually in there pretty tight, so it will take quite a bit of force to get it loose.
×