Map sensor on suzuki reno needs to be replaced, where is it?

Easter egg hunt , 1million.

no symptoms stated, just one more hunt. ok.
no country stated?
no engine stated?, wow. we are to guess that?
Gas or Diesel.?
not only that , there are 2 EFI system (3 really) MAP or MAF based
some EFI system today use both, (in a smart fashion)
on some cars the map is only used for the EGR test. so..... ????
the car is half GM and Daewoo, in a complex mix of BS.
i say sell it, Suzuki is DOA in USA and Canada, chapter 11. sell it.
here is the engine line up
1.4 L E-TEC I4 (petrol)
1.6 L E-TEC I4 (petrol)
1.8 L Family II I4 (petrol)
2.0 L Family II I4 (petrol)
2.0 L RA 420 I4 (diesel)

Deowoo could not sell cars here. so Suzuki tried and failed.
all this is bad for you and for finding parts.
and add GM engines? wow.
good luck with all that.

the FSM is here for 4 bucks
read it, or post back the symptoms.?????????

https://suzukipitstopplus.com/Products/1035-2008-forenza-reno-service-manual.aspx

ill google for you.
read that, then ask what they mean.
or read the FSM. IT TELLS YOU !

https://www.google.com/webhp?gws_rd=ssl#q=suzuki+reno+p0107


107
MAP: 5 kPa, 37.5 mmHg or less (Low pressure-High vacuums-Low voltage)
the Map connect fell off , or was cut?
the reading 5KPa is insane low.

bad map or the vacuum port to it is blocked (gunk) or wires cut to it.

did you try googling this?
do that and get like zillion hits.
try this.
2006 Suzuki Reno new key fob.
here ill type that for you.
https://www.google.com/webhp#q=2006+Suzuki+Reno+new+key+fob.

no prob.,. there you go.

Should be under the valve cover

http://www.2carpros.com/questions/suzuki-reno-2005-suzuki-reno-cam-shaft-position-sensor-location

P0107 Manifold Absolute Pressure/Barometric Pressure ...

hi.
see if this link helps you out.
2008 suzuki reno is overheating Google Search

What two sensors? When a battery is disconnected and replaced, the car needs to start and stay at idle for about 20 minutes to relearn the timing etc...only then should it be taken for another 20 minutes of normal driving on road and highway at normal speeds...this should fix the issues. Start by disconnecting and reconnect the battery leads...turn to start position without starting...leave 2minutes, turn off..wait, turn on and fully start.... leave idling awhile as above...

Nope, disconnect the battery before install and reconnect it when your done.