No gauges on dashboard are working
SOURCE: 1999 Jeep Wrangler Dashboard
A poor connection at the self docking connections of the cluster. Remove the trim across the top of the intrument panel. Remove the screws at the top of the cluster trim and remove the trim. Remove the cluster screws and cluster. Apply dielectric grease to the self docking connectors of the cluster and reinstall. This should take care of it.
SOURCE: Dashboard Gauges stopped working on '96 Jeep
If you wired anything into the fuse panel, check those fuses first. You can test all of them with either a test light or meter without removal. Just probe into the cavity at each end of the back of the fuse. Sometimes it matters which side of the fuse you used to supply power (dosen't make sense but I had that happen a few weeks ago). If fuse is not blown take power from the other end of same fuse and see if it works. If you did blow a fuse, try another connection source. I can't tell you which fuse because I don't know what you tapped into.
SOURCE: jeep cherokee 1998--After replacing steering wheel
well the check guages and airbag lights are most likely not related, the airbag is most likely the clockspring contact under the steering wheel is defective, check guages means you have a gauge that is reading a problem like low oil pressure or overheating, this can be the body control module causing this as well..
SOURCE: 2004 jeep wrangler won't start. No sound, no
Check your battery and battery cables. If there is corrosion on the battery terminals clean it off and make sure the cables have a good connection.
SOURCE: Electrical system goes crazy!!
Dirty Power and Ground connections. Working from the Battery, disconnect and clean all joints, along the Harness to the Main power box, and do the same in there.
It is a Ball acher, but it will fix the problem.
Regards, DT
283 views
Usually answered in minutes!
×