I replaced a thermostat on a ford focus & now the thermostat housing is leaking coolant. what would be going wrong?
SOURCE: focus thermostat housing
if it is leakinf the cause most likely either the hold down bolts are loose aor the gasket is bad. My suggestion is remove the housing and replace old gasket with new one then use LOC-Tite on the bolts and tighten them down to 88 inch pounds of torque. also check the clamp on the upperhose to maske sure it is tight. please rate this......thanks.
SOURCE: 2.3l ranger keeps overheating, been through two radiators already.
Hello Ranger Joe, eight months and two radiators is very uncommon. Question, Have you visually confirmed the leak in the radiators or is the leak near the hose connections? Replacing the radiator, cap, water pump, & the thermostat leaves only two others, the hoses and the engine block/heads. Far fitched will be something or somebody poking holes in the radiator.
SOURCE: Coolant leak on top of intake manifold
It is Threaded and you can Use Epoxy or even Gas Line Sealing Tape to seal the Pipe. Please Rate My Response! Thanks!
SOURCE: 1999 Ford Windstar 3.8 no heat
If you have a knock or clicking noise behind the radio, it is the blend motor. The blend door is spring loaded and the gears in the blend motor are "stripped". The door is spring loaded so that the door is closed to the heater core. About 2 hours to replace and a lot of bending and stretching. You don't have to remove the dash, but all of the trim, radio, and controls will need to come out.
SOURCE: I have a coolant leak in my 2005 Ford Mustang from
I just had this happen to me we had to replaced the whole thermostat housing because its plastic it cracked no explanation why but the crack was in the very back leaking down towards the waterpump .
60 views
Usually answered in minutes!
×