2006 Ford Expedition XLT Logo

Related Topics:

A
Anonymous Posted on Jan 05, 2014

I have a 2006 Expedition that keep cutting off at lights and stop signs. I've had a complete tune up with replacement of wires. What else would make my truck continue to have this problem, it's almost

All filter have been changed as well.

5 Related Answers

A

Anonymous

  • Posted on Jun 12, 2008

SOURCE: 1996 ford ranger -3.0 ltr

Had a similar problem and it just ended up being the sensor for the EVAP controls.  Stupid I know but it fixed the rough idle. Error code was P1443. Worth a try.

Ad

scott

  • 532 Answers
  • Posted on May 21, 2009

SOURCE: runs rough when cruising at 35-40 mph

try pulling off the air breather hose and look inside at the mass air flow sensor,it looks like a wire with a diode hooked to it incase you didnt know,see if there is any fuzz on it,sometimes the air filter will lose small pieces and the mass air flow sensor catches it.If that doesnt work then you may have a fuel problem,weak pressure,causing the mass air flow sensor to read too much air so it tricks the computer to adjust the issue.

motor1258

Mike Butler

  • 6674 Answers
  • Posted on Oct 12, 2009

SOURCE: MY 98 FORD WINDSTAR STALLS WHEN I IDLE OR COMING

I'd be looking at removing IAC valve, and cleaning it out with throttle body spray cleaner, and checking mounting gasket as well. Usually some success with cleaning it & spray ports it came out of, but if not you may need to replace it.

Anonymous

  • 1033 Answers
  • Posted on Jan 05, 2010

SOURCE: 2006 expedition hesitating during low speed excelleration

Try cleaning the throttle body with throttle body cleaner. Remove intake hose at throttle end. Spray cleaner on butterfly and open throttle by hand, spray inside throttle body and let the build up run back out. Wipe clean with clean dry cloth, and repeat. It will be hard to start after putting back on, but it will start with 5-6 engine turns. It's the cleaner in the throttle. The injectors ca be cleaned with them in, they will run clean the fuel system. I usually buy Lucas injector cleaner and add 109 octane booster from wal-mart or your local parts store. Lucas is wonderful and the booster will clean your system. A lot cheaper than a shop cleaning it.

Anonymous

  • 310 Answers
  • Posted on Feb 27, 2010

SOURCE: HesitaTion on low speed acelleration on 2006 Expedition

if it was me i'd call the dealer because at 56000 miles there is still some warrenty left i know i work for ford or repalce the filter again and add some gas treament to it youmight of pick up some badfeul somewhere

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

I have a 2004 ford expedition it falls deed when i stop at red light and when i stop for a stop sign but it start right back up and runs good until i stop for red light then it fall deed need help i chane...

simple test to do
apply the hand brake
start the engine --if it idles ok --no engine problem
apply the foot brake --if it stalls ---replace the brake booster
if it runs ok --run the fault codes
0helpful
1answer

I have a 2006 Suzuki Forenza. I have trouble starting the car once it sits over night. Once I get the car started it's kind of shakey and rough. The engine revs up and down on it's own for about a minute...

ok you might have a vacuum leak going on listen for a high pitch suction under your hood can be cause by broken or loose vacuum hose or EGR valve might be clogged or need replacing
1helpful
1answer

I have a 05' Ford Expedition and the sign "check electtronic throttle control light" keeps coming on avery now ant then. The problem is that it stops and it is very dangerous when driving on the h

I had same problem with my 2005 Expedition. The solution for mine turned out to be a dirty throttle body. Cleaned the inside of it with rag and carb. cleaner so that the throttle plate wouldn't bind and no more problem.
0helpful
1answer

My 2006 mustang cuts out when I stop

Hi Having a great Time, take the vehicle for a diagnostic scan. It seems to me that the vehicle needs a tune up and there may be another fault or two. Regards John
4helpful
1answer

I have a oldsmobile alero coupe and it keep cuttin off when it comes to a stop like at a stop sign, red light...etc..i had a tune up done and two parts replaced and it still keeps cutting off hwen come to...

MANY THINGS WILL CAUSE CAR TO STOP WHEN YOU COME TO A STOP.YOU COULD HAVE INTAKE MANIFOLD VACUUM LEAK OR VACUUM HOSES LEAKS.SCAN VECHICLE FOR FAULTY IDLE AIR CONTROL VALVE.FAULTY EGR VALVE STUCK OPEN.BAD SPARK PLUG OR WIRES.BAD FUEL INJECTOR.STOPPED UP FUEL FILTER OR FUEL FULL OF WATER.TORQUE CONVERTER VALVE SOLENOID FAULTY KEEPING TORQUE CONVERTER IN LOCK UP POSITION.USE A SCANNER BECAUSE SO MANY THINGS WILL CAUSE STALLING PROBLEM YOU HAVING. SCANNER WILL HELP FIND PROBLEM QUICKER SO YOU WONT SPEND LOTS OF MONEY GUESSING.
0helpful
1answer

How would a 2006 ford expedition run with bad gas in it

It could consist of skipping, engine cutting off or hesitates from starting, idling . Bad gas gives numerous signs, the best way I have found to deal with this is, Buy a octane booster 104, go to the gas station and put a couple of gallons of high premium in to tank to disperse the water in the gas. They also make a liquid to take water out of gas which also goes into the tank.
0helpful
1answer

99 clk heavy vibration when stopped at a light

Have your Motor Mounts and Tranny mounts checked.
0helpful
1answer

Car cuts off at red light or stop sign. {1995 Toyota Camry)

most likely a bad egr valve and vsv valve. stuck open position.
Not finding what you are looking for?

49 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...