Drove into garage, running fine. Next day no start. Cranked fine. I got back home today it cranked about 10 revolutions and no crank. Getting power to the ignition switch, I can jump the starter relay and cranks fine. ASD relay does not trip, fuel pump relay does not trip. I don't have a wiring diagram, and minimal Chrysler experience. No carb and no points, I'm semi lost.
Sounds like the crank position sensor. check continuity and 5volts reference at sensor. you can have it checked by someone with a Good scanner(SNAP-ON). If it happens to start up,drive the car till it wont start up again; unplug the crank position sensor and count to 5 then plug it back in. If it starts then its the crank sensor.(just a quick way to test it and get you home or to a shop)
SOURCE: 2001 pt cruiser limited won't crank
needs a battery but be careful cause sometimes a bad alternater will cause the battery to go bad
SOURCE: 0 degrees F won't start
how old are the spark plugs ? if the gap had a wide gap from wear it will show it self on a cold start . i would start there , do the simple things first
SOURCE: where is the crank sensor located on 2005 chrysler pt cruiser?
the crank sensor is located on back right side of engine by were the trans. bolts up.is the no start when could or hot?
SOURCE: my 03 pt cruiser won't ignite or crank all lights
How is the oil pressure or low oil. Did the car over heat is so you may have to replace the oil pressure sensor.
SOURCE: I went out to warm
First unhook the battery for about a half hour to reset the computer.
does that have anti-theft on it.
a remote starter ?
second either swap the relays for the starter and fuel pump or replace them outright.
when you bypass the relay to get it to crank... will it start ?
Robert
if that radio is of the anti-theft variety make sure you know the code and how to enter it
611 views
Usually answered in minutes!
×