ENGINE OIL pressure, sender. NO ENGINE STATED so I FAIL>
I4 or V6 engines? and displacement.
why? getting a warning light or PCM scan code for pressure.
please do provide the context of the question, what did you SEE?
ENGINE MAINS or VVT-pressure Vtec switch?
you can look anything at alldata.com so can you. or the FSM.
let me guess. here. VVT failure. vtec
http://www.youtube.com/watch?v=7ZvfPbCz3cc
SOURCE: 2000 Honda Accord PCM location
If you pull down the carpet on the passenger front floor area, it's in the center "hump" area behind the radin console mounted to the floor.
SOURCE: My 2001 Honda Accord will not start, do I need a new starter?
if you turn the key and engine fails to budge ,are you getting a clicking sound as if their is life from your startermotor ,if so maybe your solenoid is sticking which is part of your starter. give it a tap with a hammer .if it doesnt cure the problem than your starter is faulty. or even select nuetral on your transmission and try then.
SOURCE: 1996 Honda Accord need to change transmission fluid and filter...
What fluid are you changing? What engine?
SOURCE: location of the oil pressure sending unit 1994
The oil pressure sender is above or below the oil filter, threaded into the side of the engine block.
Hope this helps you.
SOURCE: how to remove center console of a 2001 LX honda accord 4 cylinder
You should never need to adjust the cable what i suspect here is the back brakes need looking at ,but before i can tell you how to do it i will need to know if its
A drum brakes
B disk rear with cable to caliper
C rear disk with cable running to the interior of the disk and not to the caliper
783 views
Usually answered in minutes!
×