Driver door won't lock with key fob

Question edited to correct spelling of model muramo > Murano
Question moved to year make model category.

It must be the switch that is behind the lever on the hatch itself, or linkage to the switch. Other ideas and fixes in the link

https://www.google.com/search?q=2012+Nissan+Murano+-+rear+hatch+lock+on+door+doesn%27t+unlock

..

Free Nissan Keyless Remote Programming Replacement Key Keyfob Maxima...

2004 Nissan Maxima Key Fob Programming Instructions

2004 Maxima

IMPORTANT: Before entering programming mode, have in possession all of the transmitters you will be using on the vehicle. Once you program the transmitter, all previous codes will be erased from the memory. The other transmitters will not be functional until you program the transmitters again.

1. Close and lock all doors with the driver's side power lock/unlock switch.
2. Insert key into ignition and remove it from the ignition key cylinder at least six times within 10 seconds. Your Hazard Lamps will flash if you have performed this step successfully. NOTE: Withdraw key completely from ignition cylinder each time. If this procedure is performed too fast, system will not enter programming mode.
3. Insert key into the ignition cylinder and turn to the ACC position.
4. Within 5 seconds, push ANY button on the remote transmitter. Your Hazard Lamps should flash. NOTE: Do not press the button more than one time in the above step. If the button is pressed more than one time, the programming procedure will not be successful.
5. If there are any remaining transmitters (including the old ones), unlock then lock all doors using the driver's side power lock/unlock switch and within 5 seconds, push ANY button on the next remote. Your Hazard Lamps should flash. Repeat this step for each transmitter (including any existing transmitters).
6. Turn the key to the OFF position, remove keys from the ignition,
   unlock doors using the driver's side power lock/unlock switch and open the driver side door.

replace the latch or chek latch cables or link from lock cyldr

check locking mechanism on the door when open. You s/b able to open with key.

check the interior light switch is working on all the doors. these control the security system.

try this put key in ignition turn to number 2. then press the fob. when the door lock press again to unlock them should work of from there. remeber to replace the battery in the fob first.

can you manually unlock the lock and open the door?? Is it more than one door or just one specific door? If its just one door, yourcactuator inside the door may be bad or you have a wire issue. If its all the doors, more than likely you blew a fuse or a relay(id say fuse)

The door lock actuator in that door is weak. Need to replace it.

The key fob is the remote. But the remote type that works like a key. The remotes that you just need to carry on you to start the car or truck. That is a Key Fob.

Thanks Jay!

sounds like a ground issue to me have all grounds checked could be jus bad ground.