Question about 2000 Jeep Grand Cherokee
I need to know how to remove the sensor that is located on top of my drivers side shock, so i can replace the front shock? The sensor is located on a plastic cylinder that sits on top of the threaded portion of the shock. I have tried just gently pulling up on the sensor and that did not work.
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
There is a removable radiator support brace at the top.There are 4 nuts that hold it on. One of them also holds the battery retainer on so you need to remove that as well.You also need to remove the coolant recovery bottle transfer hose from the brace. It is sometimes a good idea to remove the fans too as they are close to the rad and they can damage the rad if you touch the fans.If I forgot something just post me back..
Posted on Dec 31, 2008
SOURCE: i have another question
Did you support the vehicle on a lift and run it, with wheels engaged?
Since you have changed all the usual suspects, Have you checked the hub bearings? It could be that, or, something stupid like a backing plate hitting a rotor.
Regarding the cat/o2 sensor thing. Cats do go bad, so do o2 sensors but, generally a code for an o2 sensor indicates a problem elsewhere, causing a lean or rich condition in the exhaust pipe, beyond the parameters of the o2 sensor. PS: check warranty on cat. generally it runs longer than many other components.
Posted on Jan 03, 2009
If you have a impact you can try spinning it until it snaps.I'm not sure how much clearance you have .Is there enough above the nut for a vise-grip.More than likely you will have to smack it with a hammer (bend it back and forth),not sure if there is room to put a nut slitter on it.Or hack saw it off if you are limmited on tools.
Posted on Dec 27, 2009
Pry the plastic clip off where it attaches to the rod and you should be able to pull the rod out from the hole leaving the clip in the hole.
Posted on Mar 14, 2010
Tips for a great answer:
Sep 24, 2011 | Chrysler LHS Cars & Trucks
Jan 10, 2011 | 1996 Plymouth Voyager
Dec 18, 2010 | 1986 Toyota Camry
Oct 16, 2010 | 2000 Hyundai Elantra
Nov 23, 2009 | 2002 Dodge Stratus
Oct 16, 2009 | 2001 Toyota Camry
Jul 10, 2009 | 2000 Ford Expedition
Jun 27, 2009 | 1999 Mercedes-Benz C-Class
Mar 04, 2009 | 2002 Chevrolet Blazer
Jul 07, 2008 | 1998 Audi A6
102 people viewed this question
Usually answered in minutes!