Just had the timeing belt kit and the camshaft position sensor replaced. Now care has engine light one with codes P2106, P2110, P1618, and P2282. Car stalls and runs rough
SOURCE: 2006 Chevy Aveo - Accelerator Pedal position Sensor - Parts
I hate to be negative but there is not a big aftermarket for your car, try googling it, if you get nothing chevy may be the way to go.
SOURCE: 2000 Chevrolet Venture multiple codes stalling and rough idle
Look for broke/ shorted wires on Crank sensor.. thanks
SOURCE: My 2003 Tracker 4-cyl 2.0L quit going down the
Yes it can. Usually a cam sensor (on GM's) will cause it to go into 'limp' mode. I do believe it is a timing belt on this model. Hopefully that did not break. If it did the engine would definately sound "different" while trying to start.
Testimonial: "Thanks for the suggestions. I decided to remove the cam cover. The upper timing chain had broken on the left side cam. Motor had been run low of oil."
The problems are at cylinder misfire detected, you should go to do some fix~~~
-------
elm327
253 views
Usually answered in minutes!
×