My 1997 Jeep Wrangler Sport wont start!!

Need to check spark and fuel start by picking up a tester for the wires it plugs in like a spark plug and has a light that will come on if you have spark the next disconnect the main fuel line to the fuel rail and turn the key to the on position if u get fuel out of it the the pump is good

Did u check fuel pump.

Replace each wire individually from plug to distributor one at a time and they will be in the right order. Or make yourself a diagram before you start, very carefully marking the first one you take off the distributor and where it came from and where it goes. Hope this helps..

check your firing order for your plug wires

I had the same problem with my 1997 Wrangler. I seem to of solved this by turning the ignition to off then depressing the lock on the immobilizer. Then waited for about 10-15 seconds after the red light on the dash quit blinking fast . Then I hit the unlock on the immobilizer and the Jeep started and ran ok. I guess the immobilizer is the culprit and it doesn't unlock initially

I had same problem. Ended up having to replace ignition switch, then gauges and jeep started right up

What engine?

You have two locations for the fuse box. One is either under the hood or behind the glove box. I would pull apart the glove box and take a look.

Replace the crank sensor.

Try your camshaft possition sensor. If it is the same as my problem I just had to replace that and it started right up. Oh and mine was built into the distributer assembly. Take off cap and pin it's the plastic thing at the bottom. Should just pop out and you have to go to the dealer to get the part. Hopefully this helps!