Where is the DRL relay switch located on 02 chevy 2500 express van

SOURCE: location Fuel Tank Pressure Sensor on a 2005 chevy express van

lOOK UNDER THE REAR OF THE VEHICLE ABOVE THE SPARE TIRE ON A CROSSMEMBER BETWEEN THE FRAME RAILS.

SOURCE: diy on fuel pump for 02 chevy express cargo van.

The fuel pump is located in the gas tank aquire a repair manual to have a detailed decription of the procedure in order to prepare for this job.

SOURCE: I have A 2000 Chevy 3500 Express Van and the brake

Hi,

When you said that you checked the brake switch, did you check it live? Meaning verified live power to the switch, press switch, and then power came out the other terminal?

If so, also verify zero power on brake press, at the offending brake light bulb terminal. You must verify the test light each time you move it...leave running lights on...

After verifying that there is no power coming, after the brake is pressed, note the wire color and find it where it comes to the steering column and test there... This would eliminate wires and connections between front and the rear of the vehicle, unlikely, but needs to be tested.

After verifying no power at that terminal, then yes the t/s switch is certainly suspece. This may be the time to get a mechanic to verify and replace the switch, there are locks, tilt mechanisms, air bags, column bearings, etc involved. Failures risk loss of vehicle control (locking or binding for example.)..

Hope this gets you going in the right direction.

Testimonial: "Thank You. I tried those things and it seemed to be the Emergency Flasher switch in the multi function switch."

SOURCE: 2004 chevy 3500 express passenger van transmission

if ur replacing it remove front grill disconnect both lines and carefully remove retaining clips from radiator if replacement is original eguipt mount & reconnect --if its a universal follow instructions usually cut off fittings and use clamps and hose to hook up

SOURCE: 95 chevy astro van, where is the a/c clutch relay?

there is no relay power from control panel through pressure switchs to compressor