Warning dash light key slash comes on but goes off on my 2001 jeep cherokee
SOURCE: dash and shifter lights in 1996 jeep cherokee wont light
Hello and welcome to FixYa . Locate the dial that controls the brightness of the dashboardlights. If the control is not immediately evident. Make sure the brightness control is turned on. If it is and the lights aren't working, the problem may be a bad fuse. Check the fuse that controls the dashboard lights Replace the fuse if necessary. If just one part of the instrument panel is not lighting up, then you have either a burned-out bulb or a wiring problem.
Passenger side kick panel fuse breakdown for a 1996 jeep Cherokee Country
01 - 25A Rear Wiper/Washer
02 - 15A Radio, Cigar Lighter
03 - Empty
04 - 15A Passing Light
05 - 30A Blower Motor
06 - 30A (Circuit Breaker) Power Windows
07 - 02A ABS
08 - 20A Turn Signal Flasher
09 - 10A Radio/Clock Memory, Courtesy Lights, Glove Box, Cargo, Dome Lights, Telltales
10 - Empty
11 - 25A Headlamp Delay Module, Horn
12 - Empty
13 - 20A Power Door Locks
14 - Empty
15 - 15A Instrument Panel Lamps, Clock/Radio and Memory, Headlamp Switch, Parking Lamps
16 - 30A (Circuit Breaker) Power Seats, Trailer Tow
17 - 7.5A Instrument Cluster Gauges, Headlamp Delay Module, Chime Module, Overhead Console
18 - 25A Rear Defrost
19 - 05A Instrument Panel Lamps, Radio Illumination
20 - 5.5A (Circuit Breaker) Windshield Wipers and Washers
This should get you going. And you can always Ask Me.
SOURCE: 99 Jeep Grand Cherokee Brake light problem
You can adjust the switch by putting your thumbs on either side of the switch plunger and pushing toward the brake lever. The switch shaft will ratchet into the new position which is will then be depressed by the brake lever when it is the brake is not being depressed.
SOURCE: 2001 jeep grand cherokee won't start.
Your dealership can read the codes entered into your car's computer every time it malfunctions. Same problem as yours, however, also gets worse, back up lights won't work, sticks in park (in the gas stationing) (very embarrassing), will only run with foot on gas, etc. It was the "neutral safety switch". $500 fix but runs and starts perfectly all the time.
545 views
Usually answered in minutes!
100% normal the operators guide told you it goes out after coming on, but of just flashes
or sticks on , engine will not run.
stated in all jeep operators guides in print.
old post.
in fact most warning lights come on key
to test all lamps,. this is a FEATURE OF most cars made. RTM.
×