How do i reset a shift solenoid for a 2008 dodge advenger
SOURCE: 2000 Dodge Sratus 4 speed auto transmission
Dave, The P0700 code is a generic fault code indicating the the TCM (transmission control module) has recognized a problem and the P0755 is the indicated problem. I'd recommend you check your transmission external electrical connector for water intrusion and corrosion at the terminals by disconnecting the connector. If nothing appears wrong, I'd then recommend you drop the lower transmission pan and take a look at the residue deposit that is laying on the bottom of the pan. You should only see a relativily minor amount of grayish, black clutch material residing there. Pay particular attention for a gross amount of this or any large particular material, including any metal, either filings or chunks, or any brass or aluminum. If this checks out to be fairly clean, then I'd recommend you replace that "B" solenoid (2-3 shift solenoid) and have the trans. pan and filter replaced.; I'd also highly recommend you have the trans flushed for anyother particular matter that may reside internally inside the transmission. You'll have to have the codes cleared and the transmission relearned for shift feel, at that point.
SOURCE: trouble with the transmission solenoid
USUALLY A SHIFT SOLENOID DTC IS REPAIRED BY REPLACING THE TRANS SOLENOID PACK ASSEMBLY..LOCATED ON OUTSIDE OF TRANSMISSION..YOU MUST BE CAREFUL WHEN CHANGING PACK..CLEAN ALL DIRT/DEBRIS FROM OUTSIDE OF PACK..YOU DON'T WANT ANY DIRT TO ENTER TRANSMISSION..SOLENOID IS A SMALL BOX LOCATED ON SIDE OF TRANS FACING FRONT OF VEHICLE..YOU MUST REMOVE TRANS COOLER LINE HOSES FROM FITTINGS ON TRANS..REMOVE INPUT SPEED SENSOR..UNPLUG PACK..8MM SCREW HOLDS IT..3 BOLTS HOLD PACK TO TRANS..YOU MUST CLEAN ALL GASKET RESIDUE THOROUGHLY BEFORE INSTALLING PACK..I'D RECOMMEND GETTING SOMEONE WHO HAS DONE THIS BEFORE IF YOU ARE NOT COMFORTABLE DOING THIS..I HOPE THIS HELPS
293 views
Usually answered in minutes!
×