Service light wrench

which service light with wrench their are two of them 01 is inside a car symbol the other is next to an oil container symbol if first on vehicle needs service its also like a check engine this one can turn on for abs-transmission-etc have vehicle scanned for a trouble code --the other is oil change or service reminder both symbols are on page 3-39 and 3-40 of your owners manual the first symbol advises to see a dealer to review the trouble code and page 5-20 explaines how to reset oil change/service light --turn key to on/run position not start and push accellarator 3x and system will reset the following link is owners manual
2004 Saturn VUE Owner Manual

About 10,800 results (0.85 seconds) Search Results

DIY: Reset Check Engine Light without OBDII reader ...

? 3:31
https://www.youtube.com/watch?v=TvBcdjLkBhU
Jul 1, 2014 - Uploaded by Christian Macias
Learn how to reset your Check Engine Light (CEL) withoutusing an OBD II 2 scanner / reader tool. Will work on just about... Also referred to as Service Engine Soon, and Malfunction Indicator Light (MIL). This is very general ...Missing: l200

Service Wrench Light - YouTube

? 1:34
https://www.youtube.com/watch?v=S8pvlJNUkW8
Feb 17, 2009 - Uploaded by richpin06a
... reset sequence; this was the reason for the two indicator lights..... My 2002 Saturn LW300 V6 has this light come on after driving 40 KM (25 ... My service engine soon light is on, on my saturns series (2001) how would i check mine?.. i dont have the scan tool, but i did hear of using a paper clip before.

How to Reset the service engine light on a Saturn S-Series ...

vehicle-maintenance.wonderhowto.com/.../reset-service-engine-light-satu...
Apr 30, 2010 - It is never a good sign when the 'check engine' light comes up on your

Same issue it was. -20 today so i let it chug away and warm up then turned off restart good to go.

Are you doing diagnostic for the code's or are you just replacing parts ? With each code in a factory service repair manual is an associated diagnostic procedure , testing electrical circuit's for what ever sensor the code is for . Sounds like you should take your vehicle to a qualified repair shop that has the diagnostic equipment an knowledge . Sounds like you have no clue how OBD2 works . Just because you have a code reader does not mean you have the ability to repair OBD 2 vehicles .

Motor Age TST Diagnosing Driveability with Global OBD II
You don't even know what the wrench light is for ! You like making part stores rich ?
The SERVICE (Wrench) telltale is pulled to ground by the powertrain control module (PCM). When the lamp is pulled to ground, current from the ignition circuit flows through the indicator lamp, allowing it to come ON. The PCM will turn the SERVICE (Wrench) telltale ON for all non-emission related DTCs that require that a telltale be turned ON (some DTCs do not turn on a telltale but are stored to aid in diagnosis).
The SERVICE (Wrench) telltale will also be turned ON if the ABS control module has detected a fault in its own warning indicator system. If the ABS system cannot turn on its own telltale, a message will be sent to the PCM through the class 2 data bus (circuit 1807) to turn on the SERVICE (Wrench) telltale.
The SERVICE (Wrench) telltale will be turned ON for 2-3 seconds when the ignition is turned to RUN for a bulb test.

1998 Saturn SL1 5 Speed everything manual except Cruise Control. Run Great. Every time I start it, it goes through it's check cycle and comes back GOOD. But as soon as I move approximately 20 feet the SERVICE Wrench Light comes on and stays on until the car is shut off. This happens every time, doesn't matter if I go forward or reverse. All checks have turned up nothing. No codes. I checked the wiring and have found nothing. I have checked and replaced any and all bulbs, including the ash tray bulb. I have replaced the Cool Fan Relay. And still the problem exist. Any feedback or advice would be greatly appreciated.

Forget the dealer
You get a check light.leave it,and go to a shop to scan it for the code.Then have them diagnose from there and repair.
You have system malfunctions on both vehicles.

If this light comes on and
stays on, it means that
service is required for your
vehicle.-- quote from saturn

according to the Saturn website it means the your car is due for schedualed maintance such as an ol change or tune up

out of timing or fuel filter clogged or water in the fuel

THE VERY 1ST THING U NEED TO DO IS FIND OUT WHAT TROUBLE CODE WAS STORED WHEN THE CHECK ENG LIGHT CAME ON, THAT WILL BE THE KEY TO THE PING ISSUE.

It is a transmission problem and is often solved by changing the fluid and filter.