Question about 2001 Hyundai Sonata

1 Answer

Need to locate inlet/speed sensor on trasmission

I have the check engine light on in my car. it calls for a inlet/turbin speed sensor. i have bought the part but now i need to locate it on the transmission. but i dont know were to look. can you please help thanks Ben.

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 77 Answers

Look on the engine, not the transmission. It should be below the air intake manifold on top. I haven't done one of these in a while so search around and let me know how you make out.

Posted on May 04, 2009


1 Suggested Answer


6ya staff

  • 2 Answers


Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where's the transmission speed output sensor located on 2007 Pacifica 4.0 6cyl fwd

It is located on the outside of the transmission case, I assume you mean the vehicle speed sensor and no the turbine shaft speed sensor. If the speed sensor is defective you will have a check engine light on in the dash display. If that is no the case then you may have a failed speedometer.

Aug 02, 2016 | Cars & Trucks

1 Answer

Location of input/turbine speed sensor

Some are on the outside of the transmission, some are on the inside. No year,make and model.

Nov 14, 2014 | Cars & Trucks

1 Answer

Input turbine speed sensor location

Hi Mario, I may be behind times, but believe the sensors you're referring to are the turbine pressure sensors. There are usually two, mounted onto he turbo inter-cooler. Regards John.

Apr 21, 2014 | 2002 Honda Odyssey

1 Answer

1997 Saturn SL2. Engine light is on. The Diagc ode is 0717 Input/turbine speed sensor a circuit no signal. The shifting is a little rough. i have several medical tests in the next two weeks. Will it...

your car is equiped with an input/turbine and an output/turbine sensor the purpose of the sensors is check for slippage in the automatic transmission if one of the sensors is not working then the onboard computer system will opreate in limp mode and turn on the check engine light or service engine soon light witch ever one your car has, but you will still be able to drive the car it just will not shift real well intill you get the sensor replaced.....good luck

Aug 24, 2011 | Saturn SL2 Cars & Trucks

2 Answers

My Ford winstar 98 is having OD light on. Same time while I'm driving this car is slipping. I took it to trasmission specialist who took reading and out of 9 codes 5 is transmission related, but...

Try to replace the sensor yourself. Its accessable throgh the left front wheelwell, next to the axle. It is a 8mm or 10mm bolt holding the sensor in. Good luck. Turbine Shaft Speed (TSS) Sensor Removal and Installation
  1. Disconnect battery ground cable (14301) and positive battery cable. Refer to Section 14-01.
  1. Raise and suitably support vehicle on hoist. Refer to Section 00-02.
  1. Remove LH front tire and wheel assembly.
  1. Disconnect turbine shaft speed (TSS) sensor electrical connector.
  1. Remove one bolt and TSS from transaxle.
  1. To install, reverse Removal procedure. Tighten TSS retaining bolt to 9-12 Nm (80-106 lb-in).

  2. ddll111_36.gif

Mar 10, 2011 | 1998 Ford Windstar

1 Answer

I need to locate the vehicle speed sensor on 2006 4 cylinder Nissan ALtima

if its a po725 code its engine speed fault ,replace crank sensor.for vehicle speed there are two identical sensors near each other on called revolution sensor other is called turbine speed sensor.

Feb 05, 2011 | 2006 Nissan Altima

2 Answers

Check engine code PO715

Transmission Input Speed Sensor (G182 VAG com code): Circuit Malfunction
The Input Turbin Speed Sensor is located inside the transmission, the code can be caused by a failed sensor or sensor wiring or a slipping transmission.

Jan 16, 2011 | Volkswagen Golf Cars & Trucks

1 Answer

Having the same problem the other guy described.

First of all, these codes are what are called "Powertrain Trouble Codes' (that's what the "P" means P=Powertrain). TCM Request (Transmission Control Module = TCM). The request was to turn on the 'Check Engine" light.
P0720 - output speed sensor circuit malfunction
P0715 - Input speed sensor (turbin speed) circuit malfunction
P0442 - Evaporative Emission System Leak (Small Leak)
P0455 - Evaporative Emission System Leak (Large Leak)
Check fuel filler cap problems - for Evap Emiss leaks
Replace the pulse generators & have the trans fluid replaced/flushed.
The Main Catalyst System Efficiency Bank 1 Is P0420, not P0442
If you had P0420 code, the catalytic converter is shot... and that's an expensive component.

Oct 06, 2009 | 2001 Hyundai Elantra

1 Answer

Speed Sensor

The Speed sensor on your Honda Accord 97.
Is located on the Transmission.
If you follow the Lower Radiator hose from the rad to the engine.
The hose end on the Thermostat housing.
OK.. Just on direction of the thermostat housing .
Under the housing you Will see on the transmission the Speed sensor, with a connector of 3 wires. Is the only sensor at this
Part of the Transmission..

Ok. I hope this work on your question.
Thank you for use fixya..

Sep 09, 2008 | 1997 Honda Accord

Not finding what you are looking for?
2001 Hyundai Sonata Logo

301 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts


Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides