SOURCE: Replacing headlight in 1996 Chrysler Sebring JXI
piece of cake....
take off the two "star" bolts, one toward the center of the engine above the light assembly and the other toward the fender (it is very long). when you remove them both the entier assembly falls off into your hands and makes changing the bulbs much easier.
SOURCE: I have a 2000 Chrysler sebring that wont idle.
check to make sure all vacuum lines are on especially the one behind the throttle body also get a digital volt meter and check out your throttle body position sensor and also ask yourself when was the last time the fuel filter was changed
SOURCE: replacing headlight bulbs on a 2006 chrysler sebring
Behind the headlight you should see a eletrical wires running to the headlight section. There will be a 2 inch round plastic ring. You grap the back of the bulb and turn it to the right which will release the bulb and the socket. You pull out the bulb and replace it the same way. If this doesnt help then get back to me.
SOURCE: 2004 chrysler sebring driving down the just died
odds are crank sensor
could be timing belt does it have 180lbs of compression in each cyl.if not sorry
SOURCE: replace air filter 2002 Chrysler Sebring convertible
you need to loosen the clamp on the throttle body and unplug the map sensor then there are two clips on the other end pull that out and you should be able to pull the filter out you don't need to take the box off.
159 views
Usually answered in minutes!
×