SOURCE: location of fuel filter-1990 Geo Prism
Right under the master brake cylinder, its really hard to replace it. It has 2 screws, one bolt on top and the bottom one needs to be screwed off under the car
SOURCE: where is the water pump on 93 geo prism, small engine
You're right. it could very well be your water pump, but I would suggest replacing your thermostat before trying to tackle replacing your water pump. However, if your thermostat turns out not to be the problem, I have enclosed step-by-step instructions for removal and re-installation of your water pump. Hope this proves to be helpful. Have a nice evening!
1993 Geo Prism Water Pump Removal/Installation
To install:
SOURCE: 1994 geo prism will not start but does turn over
i have a 95 corolla which has same motor, i replaced distributor coils all that turns out it wasthe am2 under thehood fuse box
SOURCE: 1995 4x4 geo tracker front wheel bearings
first you remove the wheel then the break caliper then remove the locking hubs just remember to lay out the parts in order a special tool is called for but this job can be done without it you have to use a small cold chisel and a hammer to tap the large nut counter clockwise to remove, you can then remove the outer bearing and the rotor and hub assembly look on the back side reomve the bearing seal and inner bearing be sure to pack your new bearings with grease before you reassemble . takes less than an hour.
214 views
Usually answered in minutes!
×