There are panel removal tools available, but any flat prytool will suffice to pry panel away. There are also screws located at the actual door pull/handle area to remove. after loose, panel must be raised vertically as the top trim/rubber will be hooked @ window opening. there are also wires to be watchfull of and clips to disconnect before panel will be successfully pulled away. Reinstall is just the reverse procedure.
SOURCE: Power windows, door locks and mirrors inop.
Sounds familiar - I pulled the rubber boot back and found the black wire was broken. I stripped the wires and put on a couple bullet connectors (terminators) and all is good. Just wish I would have seen this post before I took the door panel off... Oh well...
SOURCE: Power windows and doors not working from driver's side buttons
you have a broken wire in the loom between drivers door and body repair this and all doors and windows will operate ok again
SOURCE: How do I install a driver dide door handle on my
Inside handle, no, outside yes, to access nuts/bolts on back side.
716 views
Usually answered in minutes!
×