1995 Jeep grand Cherokee Limited, 5.2 liter. Will not crank when ignition switch is turned to starting position. All warning light and such come on when switch is turned on but when turned to the start position, nothing happens. I bypassed the starter switch with a manual switch and it will start when I put switch into run position and push manual switch. Now the #11, 15 amp fuse in Power Distribution Center fuse box keeps blowing and therefore will not start.

SOURCE: 1995 Jeep Grand Cherokee seat belt light does not go out.

Hi,
First of all, I take it you are using your seatbelt.
There is a small micro switch in the bottom of the seatbelt plug.
Check that it`s still in place. It`s only a contact breaker switch.
You could unwire it to stop the annoying light, but will need to fix it for the next MOT

SOURCE: 1995 jeep grand cherokee wont start

IF THE FUSE BLOWS IMMEDIATELY, THE VEHICLE HAS A SHORT IN THAT CIRCUIT. CAR WON'T RUN WITH A SHORTED ECM. CHECK THE WIRING FIRST FOR A BARE OR PINCHED WIRE.

SOURCE: My 98 jeep grand cherokee wont start.

fuse 8 40a supplies power to starter relay and ignition switch, to close the starter solenoid and engage the starter which draws directly from the battery. check to see that the starter relay is closing, if not ensure that the park neutral switch is not faulty (open circuit), it provides path to close relay (ground side) on the 85 - 86 terminals. if the starter relay does not close the starter will not run. if you have a spare relay swap out the relay for a quick fix attempt. hope this helps

SOURCE: My 1995 jeep grand cherokee Laredo won't start, or

jeep grand cherokee lerado 95, wont turn over, i have replaced the crank shaft position sensor, the alternator, distributor (the whole thing, cap rotor, and the whole distributer), i have replaced the starter, and batterey termanals, also brand new fuel pump (mine was failing so i bought a new one). i also replased the spark plugs and the cables. the jeep sounds like it wants to start but it just wont. also i got it up and started and drove it around the block a few times, and then waited for it too cool down, 6 hours later it wont start....does anyone know whats going on, i really need my jeep fixed before school starts again, which is in 2 days, any advise will be appreciated.