Code scanners plug in to your diagnostic port. usually under the dash near the steering column..
SOURCE: suzuki grand vitara 2.0 TDI
check ignition system, clean fuel system, check all sensors
hope this helps
Thanks for using Fixya
SOURCE: where is the starter for a 2000 suzuki grand vitara located
starters are normally located at the rear of the motor usually hard to get too or see. should be on your bell housing in other words just in front of the gearbox/clutch
SOURCE: where is the thermostat on a 2002 suzuki grand vitara?
grab the top radiator hose, follow it back to the engine. Where the hose connects, is the thermostat housing. The thermostat is inside. Remove 2 bolts, and you'll see it.
Thanks for using FixYa - A FixYa rating is appreciated!!
SOURCE: 2002 suzuki grand vitara brake warning goes on and off
Do you have a brake fluid accumulator(ABS)? If yes, the pistons/pulsing assembly are worn, and may need to be replaced.
If not, you may have a vacuum leak in the power booster (located on the firewall). Check all hose and clamps for a tight fit/cracks,etc. Vacuum leaks cause intermittent brake failure lights.
You may want to park the vehicle on a clean surface, pump the brakes a few times, and check for brake fluid leaks. If there is a leaking wheel cylinder (back brakes) , caliper (front brakes), or brake line, you will be able to see it.
Leaks cause pressure loss, and, thus, the brake warning light will illuminate.
SOURCE: central locking fob
Programming
When
Remote control buttons operated repeatedly while vehicle out of range and system becomes inoperative. System malfunction.
How
Ensure ignition switched OFF and all doors closed. Proceed as follows: Within 10 seconds, open driver's door and switch ignition ON. Within 10 seconds of switching ignition ON, switch ignition OFF. Within 20 seconds of switching ignition OFF, press and release driver's door contact switch 3 times. Within 10 seconds of releasing driver's door contact switch, switch ignition ON then OFF. Within 20 seconds of switching ignition OFF, press and hold both remote control buttons in turn for at least 5 seconds. The driver's door should lock and unlock once. Within 5 seconds of driver's door locking/unlocking, press remote control lock button Fig. 1 [1] or unlock button [2]. Programming procedure complete. Confirm programming has been successful by locking and unlocking vehicle.
NOTE: A maximum of 2 remote controls can be programmed.
186 views
Usually answered in minutes!
×