How do I remove the inner door panel
SOURCE: Broken handle on sliding door behind driver
First get vin call toyota parts dept/ get the part its really easy to put in look for screws in little pop ups take screws out then go from the bottom of the door and lift out then go side do the same thing then lift from bottom of door and upward then you will take of vapor or plastic sheet then you just replace the handle thats it then out it back together/ Please rate my response thank you very much
SOURCE: Mazda 5 replacing external handle on sliding door
Your door should be held on with clips. Removing the panel is sometimes hard, just take a good WIDE flat head screwdriver, and whatever tool needed to remove the screws holding the panel on, and be careful. Check underneath the panel, by the inside handle, and the arm point for screws. Once removed, take your WIDE screw driver, and don't quite pry them off, more or less try to get it underneath and pull towards yourself. There is no real easy way, just try to be patient with it, and if you hit any binds, look for more screws, its just a matter of patience for sure.
SOURCE: Im looking for a sliding door handle for a 2000 nissan quest van.
ebay has them all the time also, go here for help on Quests http://autos.groups.yahoo.com/group/villagerquest/
SOURCE: how to take off driver
Check door pull for a couple screws and check bottom of panel for more screws.Take a putty knife and pry out panel at lower outside corner very gently and look in to see if there are plastic pins if there are,put the putty knife next to pin and carefully pull out on panel.Do that around panel until it is loose then panel will come of.If there are no pin the panel is held on with what looks like a ell bracket,in that case with a little effort the panel should lift straight up, not straight out.It has been a couple year since I have done one of these but one of these ways should work just don't pry to hard on panel.Good luck
SOURCE: how do i replace the door handle on the sliding
These are fun,. it would be in your best interest to contact your local library and see if they have the chilton and or haynes repair manual for your vehicle in stock,. if so, go take it out and read it as this can/ will be tricky at best otherwise.
If your local library doesn't have it, try your local auto parts store for around 25 bucks...
FYI: CALL FIRST & CONFIRM the book is there, otherwise it may have been hijacked from the library and not recorded...
750 views
Usually answered in minutes!
×