Ok here is what I just did. From the inside I removed the handle bolts and the two screws on both ends. (Be sure the other side is pushed in and latched). Then I used a punch and removed the two hinge pins on the roof. ***WITH SOME HELP*** push the release button. Careful for the door will pop out due to the cylinders pushing outward. At that point I removed the molding to access the latch. *Note---there are two more screws on both ends of the molding.* From the inside you can now reach the latch and release it. Again be careful the other cylinder will push out and the door will drop until it reaches the end of the cylinder stroke. Now you will need to re-pin the hinges at the top. From there I located the broken plastic clip that caused all this discuss. I temporarily removed the latch so I can still use the van until I get to the parts store plus it seems as if it will be easier to replace the clip. GOOD LUCK ! ! !
Jaguar 2000-06 - Locks & Lock Systems
Power Door Locks - Removal & Installation
Door Lock Switch
Door Lock Diagnosis & Testing
Fig. Removing door lock actuator
Fig. Removing door lock motor-Sedan
839 views
Usually answered in minutes!
i have the same problem .. did you fix it?
×