SOURCE: how do i replace the pcv valve on a 2000 explorer xlt v6 sohc?
On the passenger side of the intake manifold, coming off the bottom
about the center of the engine front to back, you'll feel a hose that
comes off a nipple. That hose makes a 90 degree bend and goes around to
the rear of the motor. Where that hose meets the Y-connector from the
other side of the intake you'll find the PCV valve. It's almost
impossible to see it with the hood installed, and even tougher to reach
it.
A good source of information for Ford Explorers can be found here
SOURCE: 2002 Ford Exlorer XLT
That year Explorer was notorius for rear ABS sensors going bad. If your ABS light is on as well this may be your problem. Also they were notorious for 4WD modules going bad. This problem is more expensive. I would advise you to have it checked on a computer to see what codes you have.
SOURCE: 2002 ford explorer xlt 4x4... Vehicle won't start
My 2002 Ford Explorer have the same problem
SOURCE: Location of Speed Sensor 1998 Ford Explorer XLT
polarcycle is right but there is a speed sensor on the drivers side top of the trans. toward the tail shaft or transfer case. there is as well a sensor inside the trans. itself that is mounted on the web. behind the overdrive band and drum.
176 views
Usually answered in minutes!
×