SOURCE: reset change oil display 2008 jeep
1. Turn the ignition switch to the ON position (Do not
start the engine).
2. Fully depress the accelerator pedal slowly three
times within 10 seconds.
3. Turn the ignition switch to the OFF/LOCK position.
NOTE: If the indicator message illuminates when you
start the vehicle, the oil change indicator system did not
reset. If necessary repeat this procedure.
SOURCE: Hazard lights will not turn off!
sounds like you will have to change the switch for the emergency flashers
SOURCE: 2008 jeep wrangler how to reset service light
there are two ways to reset the light. you can use an obd2 scan tool to read and reset it or you can pull your battery cables off for a half hour and that will also reset it. just be forewarned if you have not fixed the problem that turned it on in the first place it will just come back on. if you have fixed the problem after 50 starts without seeing the issue again it will also clear itself.
SOURCE: 2008 jeep wrangler how do you reset the service
turn jeep off...press gas peddle quickly 3 times..wait 15 seconds...turn car on. if it doesnt work, adjust the speed of pressing gas peddle.
SOURCE: my 98 jeep wrangler radio, turn signals, and
Possibly the buss bar in the fuse box, but I'd bet on a fusible link or a master fuse.
192 views
Usually answered in minutes!
×