Hello have a 2006 Isuzu I-280 and I needed to replace, at this moment, the Evaporative Valve Soleniod which is instaled next to the Vapor Canister. In my case, It is mounted on the frame behind the gas tank you will have to move the spare tire out of the way one bolt holds it in place, this is where the canister is and the valve is mounted on the canister this is where it is mounted on my 2006 I-280. If you need to replace the solenoid and you can't find the original Isuzu part, you can ask for the 2006 Chevy Impala V-6 3.5 Purge Valve Solenoid. It is the same piece. The old Evaporative Vent Valve Solenoid has a number part PA-GF30, and it is the same part number I found in the new Chevy Impala Evaporative Vent Valve Solenoid. Good luck.
SOURCE: I need to locate the canister purge valve and the
look above the spare tire under the back of the box
SOURCE: LOCATION OF VAPOR CANISTER PURGE
Your best to have a Repair Shop properly diagnose the
entire EVAP System
You may not need a Purge Valve
They will use an EVAP Smoke Machine and
Scanner to do the job correctly
SOURCE: Mustang GT 4.6 EVAP Canister Purge Valve Location?
You will need to remove the right front wheel & wheel well liner. The canister purge valve is behind the cover. It should have two tube going into the bottom and one on the side near the top.
You can fix it!
If this helps you out please rate me!
Brett
390 views
Usually answered in minutes!
×