RPM high n everytime i shift then car speed keeps on going fast n i dont even step onto the accelerator so i can add more speed of stay on a constant speed

Hello. It seems one or more of your car's 'fuel injectors' is/are 'flooding' your cars engine. The excess fuel 'ignites'; making the engine 'race' at high engine speed yet it won't accelerate. Good luck and keep me informed; if you want to.

sounds like your transmission is shifting stuck in High gear

check the rpm and road speed when this happens . The cruise control will increase to keep RPM constant but as the road speed drops the auto may be shifting down and as the rpm increase it shifts back before the rpm adjusts. You can override a cruise control in this situation by simply pressing down on the accelerator to maintain the power setting and road speed and when the situation is passed and you take your foot of the accelerator the cruise control will return the system to the set position without you needing to do anything

Does the engine accelerate okay? Shifting to any other gear help? Check the transmission fliud level, if it is full (and brown or black) you need a rebuild, if it is low add fluid to full mark and try again.

For this types of problem,there are few help inks to troubleshoot the problem.Click the link below to go through the troubleshooting procedure to resolve the issues :----Idles rough and quits when gas pedal is pressed less? http://technoanswers.blogspot.in/2012/01/1999-ford-f-150-idles-rough-and-quits.html-----------van idles rough? http://howtobyme.blogspot.in/2012/01/2004-ford-freestar-van-idles-rough.html
--------------runs lean and idles rough? http://technoanswers.blogspot.in/2012/02/ford-runs-lean-and-idles-rough.html
-----------Car still runs Rough after tune up? http://howtobyme.blogspot.com/2011/12/car-still-runs-rough-after-tune-up.html
------------Idle flair is noticed on car? Rough idle? car will not idle? Erratic idle speed? http://technoanswers.blogspot.in/2012/02/idle-flair-is-noticed-on-car-rough-idle.html
----------High rpm in neutral? Inconsistant high RPM in neutral? http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html
------------Engine Backfires? http://technoanswers.blogspot.in/2012/02/jeep-backfires.html----------- Nissan stalls and bucks on Acceleration?

http://technoanswers.blogspot.in/2012/02/nissan-pathfinder-stalls-and-bucks-on.html

-----------
Nissan Pathfinder Backfires? http://technoanswers.blogspot.in/2012/02/nissan-pathfinder-backfires.html
---------How to adjust rpm? http://schematicsdiagram.blogspot.com/2011/12/how-to-adjust-rpm-on-2009-dodge-charger.html
------------Engine cuts out at 3000 RPM? http://schematicsdiagram.blogspot.com/2011/12/engine-cuts-out-at-3000-rpm.html
----------This will help.Thanks.

try to reset the computer if that doesnt work reset the idle speed it may have picked up bad codes

It could be your transmission trying to find the right gear it will jump around on diffrent road surfaces and going up hills/down hills. It is usaully noticable on cruise because it is at a constant speed and your thinking why would it need to shift. Sometimes it doesnt even really shift the gear its so inbetween it just jumps back really fast.

With normal acceleration the 1st to second shift point should be around 2500-3000 rpm. Most of your shifts under moderate acceleration will take place at this same point or when there a light load on the transmission. Under hard acceleration the RPMs will climp higher due to increased power needs and the computer will shift when less power is needed or the RPMs climb to an unsafe speed say5000-6000rpms (depending on where yours redlines). Also going up a steep hill will raise the RPMs higher and goind down a hill will cause a faster shift at lower RPMs. These can always be altered by an individual owner by adjusting shift points, using performance parts and if you have problems (low tranny fluid/trans issues). Your trans RPMS are fine and will vary depening on how your foot accelerates. The shift pattern should be the same every time you drive slow/medium/fast/, look for changes in those patterns you will also catch a problem early.

Ok you have a 4 cilynder engine, and you transmission is bad, and you are forcind the engine because you need more RPM that the normaly need it for certain speed, don't continue ussing you car like that because you will brake you engine too, and you will spend depend where do you live

a use transmission around $ 7 or $800.00 Rebuilt around $ 1200.00

I had the same problem with my 96 Ram 1500. I thought I was going to have to pull it out and get it rebuilt or just replace it. That was at 134,000Km it's now got 210,000 and shifting like a dream. What I did to solve the problem was this, as follows:
1. No lucas transmission Fix makes things worse.
2. Get your self a new transmission filter and gasket
3. Grab Gunk transmission medic 12oz
4. Grab 7 Liters of Valvoline ATF+4 transmission fluid (Made for chrysler transmissions)
5. Drop the trans pan and drain all the oil, clean pan and magnet
6. start truck for 5 seconds and the pump will pour out another 1 liter
7. re-install filter, gasket and pan, then add your Valvoline ATF+4
8. Add, the valvoline, transmission medic and make sure you have the right level of fluid

That solved my transmission problems, instantly it was shifting better, I no longer had to let off the gas to make it shift. Now if you have large pieces of metal on the magnet, and it's totally covered in filings, you might want to consider rebuilding the trans. My magnet had usual clutch.         

Anyhow good luck, let me know if it did the trick for you.
Justin