1995 Ford Taurus rear bumper cover is loose on one side and needs to be reattached.
The sides of the bumper slide on over a large pin to hold them in place. The easiest and correct way of getting it back on is to unbolt the bumper cover from the impact absorbers in the rear and slide the cover off by pulling it straight back. When you slide it back on, make sure the cover goes on the pins on each side before pushing it all the way back in place and bolting it back up to the impact absorbers. If you have been rear-ended then the tracks that these pins slide into may be broken. If thats the case you will have to replace the bumper cover
SOURCE: Rear Bumper Cover
you would need to heat it up from behind to remove the dent and the rubbing compound should work as long as it hasnt penetrated your paint layer
SOURCE: 1995 Ford Taurus brake pad replacement
the piston need to be turn clock wise and push at the same time make sure when you turn it the rubber around the piston dont get damaged it stick to the piston and get torn before you turn just make sure it not sticking to the piston at the auto part store they sell the toll to turn the piston its cheap$$ hope it FIXYA our post thanks pierre
SOURCE: Remove rear plastic bumper cover
please email me at [email protected] with any other info or questions if you have already gone to a body shop
SOURCE: where is the a/c low side service port for 1995 Ford Taurus
fire wall on paas. side of the car
SOURCE: My Toyota Corolla rear bumper has at big dent on
you have to take the whole bumper off and the bolt the u see holding it on the re-bar and bumper cover should come off
1,119 views
Usually answered in minutes!
×