How to replace the orifice tube on a 1994 oldsmobile cutlass ciera

SOURCE: The windows in the 95 oldsmobile cutlass ciera won't work at all

maybe the wire is severed where the door (drver dr) pivots. thats what was wrong with mine. there is a rubber boot with crinkles in it that hold all the wires together. you can also try replacing the switch board that controls the wndws on the drvr dr. hope that helps.

Colin Stickland

• 22516 Answers
• Posted on Jan 24, 2009

SOURCE: how to change a starter in a 1992 oldsmobile cutlass ciera

disconnect battery,three bolts hold it to bell housing and two wires ,one is the feed the other activates the solonoid Easy job to do but dirty dirt grease and muck

mike kirschbaum

• 1198 Answers
• Posted on May 04, 2009

SOURCE: 1994 old cutlass ciera 3100 blown head gasket.

Get a Chilton's book on the car. It will take you thru the whole job, and give you the torque specs for putting it back together. You will need a torque wrench, foot pounds, and a good socket set.

Dar

• 2007 Answers
• Posted on Jun 03, 2009

SOURCE: 1991 Oldsmobile Cutlass Ciera idles high

Change your idle control sensor, but first make sure your throttle linkage isn't sticking.

SOURCE: Changing spark plugs on a 1995 Oldsmobile Cutlass Ciera

ALL YOU NEED IS 3/8 RATCHET WITH A 5/8 SPARK PLUG SOCKET.YOU NEED EXTENSIONS AND UNIVERSAL JOINTS TO GET TO HARD TO REACH PLACES.YOU NEED A SPARK PLUG GAUGE.YOUR SPARK PLUG GAP SETTING WILL BE. 0.060 THAT WILL BE FOR THE 2.2 AND 3.1 ENGINES.

Testimonial: "Thank you very much for your advice and time!"