Change oil how to reset oil change light, after you change the oil yourself.

On a lot of vehicles if you hold the trip odometer reset and then turn the key to the on position it will clear the service light.

You need to reset it yourself:

to reset oil life turn key to on position.
press gas pedal firmly 3 times fast.
make sure you press firmly so pedal hits floor but dont hold it.
just press 3 times fast.
turn key off then on and the light should reset.

Skipping and jerking due to slip in transmission most likely, and change oil light needs to be reset if you changed the oil on it yourself, refer to owners manual or search online for reset procedure

Do an online search for the reset procedure. The light will stay on until it is reset. The dealer will undoubtedly charge you to do the reset and it's something you can do yourself.

She didn't do anything wrong at all. Your truck is just fine and doing what it was designed to do. That's a normal indicator that comes on to remind you to get the oil changed. It's supposed to get reset every time the oil gets changed and frequently, Quickie Lube and other instant oil change shops will overlook resetting it. Look in your owners manual under "Resetting the Service Engine indicator light" and you can reset it yourself. Or just get the oil changed and tell them to make sure and reset it.

you get an oil change and they will reset the light or you change the oil and filter yourself and read the owners manual it tells you how to reset the light hope this helps

If you changed your oil just less than three miles ago, you just need to reset the computer. In this vehicle it may be the same as other chevys. what you will need to do is turn the key to the run position. Depress on the gas pedal three times and turn off the key. this should reset the computer. good Luck

oil change might not have they obd2 tester to shut
the light go to auto parts chain store like autozone
tell shut it up for you for free

Press and hold the SELECT/RESET
control switch to select SYSTEM
CHECK when “SYSTEM CHECK /
HOLD RESET” is displayed in the
message center. Selecting this
function from the SETUP MENU
causes the message center to cycle through each of the systems being
monitored. For each of the monitored systems, the message center will
indicate either an OK message or a warning message for two seconds.
Pressing the SELECT/RESET control switch cycles the message center
through each of the systems being monitored.

The sequence of the system check report and how it appears in the
message center is as follows:
1. OIL LIFE RESET
2. CHARGING SYSTEM
3. WASHER FLUID
4. DOOR AJAR
5. EXTERIOR LAMP
6. BRAKE SYSTEM
7. PARK BRAKE
8. MILES TO EMPTY
9. FUEL LEVEL LOW (will only display if 50 miles or less to empty)
To reset the oil monitoring system to 100% after each oil change
[approximately 5,000 miles (8,000 km) or 180 days] perform the
following:
1. Enter SYSTEM CHECK to display
“OIL XXX% RESET IF NEW”.
2. Press SELECT/RESET control
switch to display “HOLD RESET IF
NEW OIL”.
3. Press and hold the
SELECT/RESET control switch for
more than 2 seconds. Oil life is set
to 100% and “OIL CHANGE SET TO
100%” is displayed.

Turn car off, then turn the key to ACC, pump the gas peddle 5 times. Turn off, then start car up that wil reset it and bring it back to 100%