Question about Ford Expedition
2000 Ford Expedition: Stalled at idle and won't restart. Engine turns over but stops when I release the key. After 5-10 minutes it started but ran really rough for 2 minutes then stalled. Won't start. Had to have it towed. In past it has run rough at idle when running A/C. Changed oil, oil filter, and air filter 2 weeks ago.
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Just check your air flow meter connections do a "wiggle" test on it (Means move the wires to it while its running) put a bit of revs on while you do it or you will not notice the differance when you find the unrelyable connection! you see the more air rushes through the air meter the more fuel it tells the ECU to supply to the engine! so every it comes out off circit the ECU thinks the engine is idleingso it just supplys that amout of fuel thats why it dies under load!
an injection system will idle with the air meter disconnected..it just wont rev up because the ECU is unaware to supply more fuel understand?
Good Man Good Luck, HOPE THAT HELPS YOU!
Posted on Mar 10, 2010
Wouldn't happen to be a diesel, would it? If so, do a search on ebay for a remote fsd/pmd module. Fixed my 95 'rado (in less than 20 minutes) with a 6.5 turbo diesel -it would stall wherever and whenever it wanted, without warning.
Posted on Mar 14, 2010
Sounds like there is a problem with the Torque converter in the transmission or Transmission itself. When you put it in gear it should initially go into neutral but occasionally the transmission will stick part way in gear and partially in neutral putting a load on the motor. It is not enough of a load to get the vehicle moving but it is enough to stall the motor. This could be a simple clutch adjustment in the Automatic clutch to a PCV valve issue to a need to rebuild the whole transmission because of a problem with the control body or transmission pump itself. Sorry for the bad news.
Posted on Apr 19, 2011
Tips for a great answer:
Jan 08, 2016 | 2003 Ford Windstar
Apr 15, 2015 | 2000 Ford Expedition
Jan 05, 2013 | 1997 Ford Expedition
Engine stalling and rough run
issue at low speeds
This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control
Aug 06, 2012 | 2000 Mazda 626
May 04, 2017 | 1999 Ford Expedition
Jun 09, 2017 | Cars & Trucks
Aug 22, 2011 | 2005 Ford Expedition
Feb 09, 2011 | 2000 Ford Expedition
Dec 07, 2010 | 2000 Ford Expedition
616 people viewed this question
Usually answered in minutes!