Question about 2000 Jeep Grand Cherokee

Open Question

CD Changer Problem

My 10-disk CD CHanger will not hold the CD Holder in when pushed down as it should. Recently had the electrical wiring and board replaced. Upon starting the vehicle, I hear the CD changer making sound as it did before as though it is loading. I've tried resetting battery to see if the cd changer would reset but problem persists. Does anyone have an easy solution?

Posted by on

Ad

6 Suggested Answers

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Anonymous

  • 4 Answers

SOURCE: Jeep RDS CD Problem

Did you change the battery ? If so try disonnecting and reconnecting the CD changer.

Posted on Dec 28, 2008

Ad

Anonymous

  • 15 Answers

SOURCE: CD stuck in changer

no dont pull fuse your cd is in up side down take out cd with a knife

Posted on Jan 27, 2009

joerocket999

joe wright

  • 28 Answers

SOURCE: Jeep Cd Changer "Disk Error" message

Well if you didn't already know all jeep chrysler dodge factory cd players don't work very well. I have sprayed high pressure air into mine and it has help but may not solve the problem permanently. I would suggest buying a new cd player. sorry

Posted on Jul 27, 2009

stevenhurc

Steve Hurc

  • 459 Answers

SOURCE: Mech Comm Error

sounds like they may have forgotten to take out transit plugs from radio which holds cd mechanism in place when shipping unless you got a new radio thats a dud? but that may also mean dealer didnt check operation of new unit after replacement if replaced which is what usually needs to be done when this error message comes up

Posted on Aug 06, 2009

Anonymous

  • 20 Answers

SOURCE: 2000 jeep grand cherokee limited 10 disk cd changer says ''err''

The in-trunk units have a tendancy to go bad. you can take the cover plastic interior cover off to access the CD changer, un bolt the changer, and visualy inspect the two rollers for debris, or missing /broken gears that move the rollers to take the CD from the CD cartrage to the player. if that looks fine, chances are that the laser went bad (common in rear mount units) and you can order a new one from Jeep, or you can remove it and update the in-dash head to an aftermarket of your choice (& yes you steering wheel controls will still work). you could also fit a more modern MP3 unit where the Changer was.

Posted on Feb 22, 2010

Testimonial: "thank you so much!I will see if that is the problem and if so, off to the store I go.I actually wasn't to keen on the cd changer being in the back."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to load disks in 12 disk changer in 1995 lexus cl400


Not 100% sure but they normally go in with the written side facing up and the data side down. Hope this helps

Jan 13, 2016 | Lexus Cars & Trucks

2 Answers

I have a 2002 neon everything. I was recently driving and I noticed all the lights on my factory cd changer were blinking, no CDs would eject, is there anything I could be doing to troubleshoot or fix this...


Unfortunately, my experience with the factory multi disk changer is no. Sometimes it is a matter of disconnecting and reconnecting to get it to a point where the system will eject the CD's. The problem actually appears to be a dust build up in the changer itself over time. It was only designed to work for about 5 years so you are well beyond that. My son was able to remove it and open it up and clean it out and got one to work for about 2 more years but in the end he ended up replacing it. Typically the gears that work the disk ladder inside jam up and cause it to fault out as the drive motor gets weak over time. In most cases to get your disk back you are going to have to open it up and manually cycle to each disk and remove it. Sorry, no really good news.

May 14, 2011 | 2002 Dodge Neon

1 Answer

I get E-01 error of my cd changer


The fault is actually inside the CD changer, when one disc is selected the changer moves the gearing inside to slot from one CD to the other.
While this operation is happening the selection arm jams !!
Then giving an error at the radio display..

To fix the problem, disconnect the CD changer from the trunk of the car,
take off the top plastic slide cover,
with a small screwdriver slowly move the gearing so that the CD disc holder will move back to the load - unload position.

Pop out the CD holder.

Replace unit, reconnect the optic and power lead, switch on radio and the unit will work again,

grease the moving parts with light lubricant

Good Luck

Feb 24, 2011 | Mercedes-Benz C-Class Cars & Trucks

2 Answers

Where is the blend door actuator loacted?


The actuator is on top of the heater box behind the glovebox area

Jun 13, 2010 | 2000 Lincoln LS

2 Answers

2000 jeep grand cherokee limited 10 disk cd changer says ''err''


The in-trunk units have a tendancy to go bad. you can take the cover plastic interior cover off to access the CD changer, un bolt the changer, and visualy inspect the two rollers for debris, or missing /broken gears that move the rollers to take the CD from the CD cartrage to the player. if that looks fine, chances are that the laser went bad (common in rear mount units) and you can order a new one from Jeep, or you can remove it and update the in-dash head to an aftermarket of your choice (& yes you steering wheel controls will still work). you could also fit a more modern MP3 unit where the Changer was.

Feb 20, 2010 | 2000 Jeep Grand Cherokee

1 Answer

The 6-disk cd changer in my '04 silverado z71 will not load or eject cds. When I push load the cd emblem on the screen goes away for a while. When I push eject it tells me there are no disks, but I have...


the laser system this damaged you have two options to repair the laser or to change to The 6-disk CD to changer but cheap is to change to the 6-disk CD to changer

Jul 05, 2009 | Chevrolet Silverado 1500 Cars & Trucks

3 Answers

A dvd is stuck in my Chrysler town and country multi disk dvd/ cd player. How do I remove it?


Look around the face plate for a very small hole...use a straightened paperclip or equivalent and press in a few inches...its a manuel door release and you should gain access to at least the loading tray.

Apr 24, 2009 | 2005 Chrysler Town & Country

1 Answer

Jeep RDS CD Problem


Did you change the battery ? If so try disonnecting and reconnecting the CD changer.

Dec 27, 2008 | 2005 Jeep Grand Cherokee

1 Answer

1998 - 2002 Honda Cassette 6 disk CD changer Radio


the cd changer is malfunctioning, the factory cd changers usually don't last that long because of the heavy use and many mechanical puts

Jul 29, 2008 | 1997 Honda Accord

Not finding what you are looking for?
2000 Jeep Grand Cherokee Logo

Related Topics:

36 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...