SOURCE: how to change a throttle position sensor on a 94
How to Replace a Throttle Position Sensor
(DIY & Save up to $135.75
) - Time: 2.1 hours
Parts:
1. Throttle Position Sensor - $ 55.44
Tools:
1. Scan Tool
2. Screwdriver
3. Multimeter
Procedure:
1. Locate the OBD data link connector (DLC). Refer to your owner’s manual for the specific location.
2.
Turn your key to the“ON” position. Do not start the engine.
3.
Plug
your scan tool into the OBD data link connector. Turn on the scan tool
and select the appropriate steps to read the diagnostic trouble code
(DTC).
Scanner plugged into OBD-II data link connector.
6. Test
the resistance of the throttle position sensor (TPS) with a digital
multi-meter. If the resistance is out of specifications, the TPS must
be replaced.
Removing sensor mounting screws
8. Install the new throttle position sensor. Tighten the mounting screws and attach the electrical connector.
Check engine light
Direct OE replacement
Hope helped with this. Good luck (remember rated this help).
SOURCE: Where is the camshaft position sensor on a 2000 Ford Explorer?
in the rear like where the dist would normaly be
SOURCE: where is the throttle positioning sensor located
Please don't forget to rate!
Disconnect and remove the TP sensor from beneath the throttle body
View of the throttle position sensor mounting-4.9L, 5.0L and 5.8L MFI engines shown, others similar
Exploded view of the throttle body mounting-5.0L and 5.8L engines
SOURCE: my 2000 ford focus se read p1120. already replaced
does your engine idle fast or slow? You may need to clean the idle selonoid or the throttle body. They carbon up and stick.
SOURCE: 95 f250 7.3 is throttle position sensor on the pedal
i have a f350 ps and it starts and idles but i have no throttle nothing happens when i push the pedal and the check engine light comes on
1,381 views
Usually answered in minutes!
×