2005 jeep grand cherokee - the front passenger power window motor works but the rubber piece on the window track keeps falling off. i have had the glass replace twice by JN Phillips and its broke again. The rubber track piece looks warped. i dont need a new motor or regulator but need to find a rubber piece. don't want to take it to a jeep dealer as they will rob me daft. please help
SOURCE: 2005 Jeep Grand Cherokee Problem
I would start by checking all the fuses under the hood.
There is a fuse called IOD which the factory leaves out and gets put in at the dealer.
That fuse could be bad.
SOURCE: Replace front passenger power window motor
not hard at all remove the door panel and you will see 5 bolts with a slot so you do not have to remove the bolts just loosen them. There is 2 clips that hold this to the window remove them. The hole thing will come out. Look on E Bay buy a new window regulator $40.
Testimonial: "Great solution"
SOURCE: how to replace window regulator on 1999 jeep grand
sorry I don't have much on this one. But, once the door panel is removed, you need to disconnect the glass from the regulator. I can't remember... but I think it is held on with U clips. They are just pushed in on the back side of the trolly. Too release them just push to one side. (see pic)
*****NOTE: this is from another vehicle but the pin is the same...in the pic. the pin is being pushed back into place.
push the glass all the way to the top of the door and tape it there. Unplug the motor, unbolt the regulator and remove.
(Im pretty sure that year had 2 pins to hold in the door glass, if I'm wrong you will clearly see 2 X 10mm bolts holding the glass to the regulator)
hope this helps.
SOURCE: My drivers side power window
If you are not well versed in taking doors and panels apart, go to an auto glass shop and they can fix it for you in less than an hour much more cheaply than a dealer. They will have the tools and fasteners in stock.
SOURCE: 1994 Jeep Grand Cherokee front
first check the switches on driver's door and passenger door , most often this is the cause. switch them around to check or use jumper wires in the connectors. motor is inside the door low towards the front. motor is bolted to window regulator assembly.
1. take off door panel and plastic liner
2. remove 3 or 4 bolts retaining assembly with window up, but mark exact location as this affects alignment
3. pivot assembly to remove rollers from track on glass
4. remove assembly through largest opening on inner door frame
5. un bolt motor from regulator
6. Install in reverse order
I am willing to elaborate on any and all of these points untill you are done, just reply to this feed for more info
1,187 views
Usually answered in minutes!
×