SOURCE: I am working on a 1999 olds alero that wont start
IF YOU REPLACE CRANKSHAFT SENSOR IT HAS TO HAS TO BE RELEARNED USING TECH 2 SCANNER.FOR THE IGNITION KEY REPLACEMENT.TURN IGNITION SWITCH TO THE ON POSITION FOR 10 MINUTES WITH ENGINE OFF.WHEN SECURITY LIGHT TURNS ITSELF OFF.THEN YOU TURN OFF IGNITION SWITCH FOR 5 SECONDS.THEN START THE ENGINE.
Instructions
Test fit a drill bit in the lock cylinder. You want a bit that is just
smaller than the cylinder. You will be using hardened drill bits to cut through
the cylinder, since ordinary bits may be damaged by drilling metal.
Lock the drill bit into the drill chuck and tighten the chuck.
production in very fast delivery! special threading taps, plug gauge
Drill a starter groove into the lock cylinder. Start the drill on a low
speed and create a groove in the end of the lock cylinder. You don't need to
create a deep hole, just enough of a groove so that the drill bit will not slip
on a higher speed.
Increase the drill speed to the highest setting and drill out the lock
cylinder. Let the drill do the work. If you force the drill into the lock
cylinder, you could burn out the rotor inside the drill motor
54 views
Usually answered in minutes!
×