Hazards lights are working in car, but turn signals are not working at all
SOURCE: 97 BLAZER BRAKE AND HAZARD LIGHTS DON'T WORK
did you check the fuses?
If so, then check the plug on the steering column....
SOURCE: turn signals don't work chevy s-10
Check your turn signal flasher, it's usually located on the fuse block, no turn signals if it burns out.
Testimonial: "very helpful"
SOURCE: 99 Chevy Tahoe... Rear turn signals, brake lights, and hazards
I had this problem, and to be honest, it happened to the left side about a week later...it's the board that the bulbs plug into...it's a very common problem with this model. So popular that you can normally get the socket board off the shelf at a parts store! it's extremely simple to replace, and I replaced all the bulbs at the same time!
SOURCE: Where is the turn signal relay on a chevy s10
On 95-97 and 1998, both the turn signal and hazard flashers are located behind the lower dashboard trim just to the left of the cigarette lighter. You can not get to it without taking apart the trim (stupid design). Or you have to drill a 2" diameter hole in the trim with a velcro cover so you would never have to do it again1999 and later it is under the glove compartment
to disassemble it without drilling
It's behind the panel to the left of the cigarrette lighter. You need a Torx 25 screwdriver and another screwdriver for those hex shaped screws, forgot the size. First unscrew the 2 Torx 25 screws beneath the steering wheel. Then unscrew the rest of those Hex screws on the bottom. The panels overlap, so be prepared for a lot of unscrewing. You do need to unscrew the middle black panel on the bottom, right beneath the cig lighter. It's held by two Hex shaped screws, one on each side and are hard to unscrew. Also you need to remove your spare change sliding tray to unscrew the last hex looking screw. Once you pop your panel off, the turn signal flasher is the right one. The Hazard flasher is the left one. You can find a replacement part at Autozone, and DON'T get the $184 Flasher switch, all you need is the signal flasher. It's shaped like a cylinder with TWO prongs on it.
SOURCE: no turn signals or hazards???
Check the FLASHER unit; the turn signal flasher is mounted in a clip on the right side of the
steering column support bracket. The hazard flasher is located in the
component center, under the instrument panel, on the right side. Replace
the flasher by unplugging the old one and plugging in the new one.
Hazard flasher -->> The
Flasher is located:
Front seating area, passenger side, under dash, below
glove compartment, mounted in fuse panel
Turn signal -->> The
Flasher is located: Front seating area, driver side, under dash, mounted
on passenger side of steering column
Good luck (remember comment and rated this).
591 views
Usually answered in minutes!
×