2002 Oldsmobile Silhouette ABS Light is on and

When the light keeps illuminating it recieves it message from the EBCM (electronic brake control module) or the ABS system,Make sure you have all the same tire size and are properly inflated,just to let you know GM has known problems with the front ABS unit,and the solution is to replace front hub and bearing. Bulletin No. 03-05-25-004A

JUNK IT

I have the same problem few days ago, and still didn't find any solution. Can any one please help?????20

theres a code in the abs system. its warning you that the abs and trac system have been disabled. have it plugged into to see what the code is. hope this helps

Hi,the traction control light coming up means there is a fault detected in the system and a scan tool will be required to learn what fault has been detected. Possible steering angle sensor, wheel speed sensor or brake pressure sensor since the light comes up when making turns or when backing up. Faults are to be checked and proper diagnostic procedures carried out before parts replacement remedies.....

check the abs sensors common to hit or damage the wiring or knock connection loose when doing a brake job the traction control system[tcs] is tied into the abs system

those lights come on when the system is shut down by the computer. You have to scan the abs system. It is usually one of the sensors. I have seen many of the front wheel bearings being the problem because the sensor is built in and when the bearing goes bad.

The ABS and Traction control both work off the abs system .

Hope this helps.

Sounds like you have a problem in the front brakes or a front wheel speed sensor. A common cause for a Traction light is a faulty front ABS wheel speed sensor or harness. When the Anti lock brake computer sees a problem in the ABS syetm, it disables traction control as well.

A common cause for a Traction light is a faulty front ABS wheel speed sensor or harness. When the Anti lock brake computer sees a problem in the ABS syetm, it disables traction control as well.

Just replaced both front bearings on my 2000 olds silhouette, the traction control light / ABS light is still on. What do i do?