SOURCE: what is the torque on the wheel hub nut set at on
look in your owners manual. if you do not have one call your tire story thay can tell you.
SOURCE: What is size of hub axle nut on 2002 chevy s10?
2002 chevy S10 ZR2
36 mm.
Torque 103ft pounds.
Testimonial: "Great, thank you! At 7 to 15 bucks a pop for one socket, it helps to buy the right one the first time."
SOURCE: We have a 2005 chevy uplander (AWD) with a broken
I have never done one on this vehicle but have replaced many on all other cars over the years, this is what i experienced, the stud will pound out with a good 2-3 lb. hammer, and the new stud and nut will get pulled back through the empty hole by use of a strong impact wrench...start the stud by hand try to pull it as much as you can through the splined hole in the axle flange, install the new nut backwards on the stud screw it down as far as you can then with the 1/2' drive impact wrench on full throttle tighten the lug nut...by doing this you are pulling the stud through the void hole.
Please remeber to use a small amount of axle grease on the new stud and hole prior to installing the replacement stud and nut.
You prbably have to remove the disc brake caliper and brake pads along with the rear disc brake rotor to gain access to the stud, there should be an access hole also allowing you to get behind the axle flange for removal and installation.
Hope this works.
Happy Motoring!!
308 views
Usually answered in minutes!
×