Reinstall nut a little loose. Tap on nut while prying up gently on wiper arm. This is what is called a morse-taper fit, and can be difficult to break loose. Also try tapping on arm with a small hammer horizontally to break it loose.
SOURCE: Where is the windshield wiper delay circuit board
You are on the right track. If you have removed that little cap, and unbolted the nut what you do is pull and wiggle. There is a special tool, but if you are persistent you can do it without the tool. A little WD-40 never hurts either.
SOURCE: Need to remove the wiper arm from my '04 Chevy Cavalier
Just pry on the side away from the arm with a small pry bar, or a screwdriver with a block of wood under it. Put a rag on the car so you don't scratch the paint. Wipers are spring loaded so that pressure is on the glass all the time. That pressure is just causing it to bind a bit. As soon as you pry, it'll pop off.
SOURCE: Replace 07 Tahoe Wiper Arm
just pull on it a little harder and it will come off Believe me I have taken off so many of them you can try Wd 40 let it soak and then try again and jiggle it. Please rate my response Thank you very much!
SOURCE: remove and replace wiper blade assebly 89 chevy silverado
there is a keeper on the inside of the arm. its easier to get to if you remove the whole arm. lift the wiper arm and near the pivot point there is a little flat bar that sticks out along the arm itself. its about a quarter inch long. pull that out alittle and slide the arm off the peg. makes it easier for me. if you cannot get the wiper off still, destroy it. your replacing it anyway and the arm is pretty sturdy.
237 views
Usually answered in minutes!
×