03 Taurus wiper problem

Maybe the nut that hold the wiper to the linkage is either loose or stripped? The linkage itself is bad?

I think your wiper motor is fine because the passenger side works and uses the same motor to move the wipers.

sounds like the connecting rod between both wiper arms either broke or one of the keepers popped off under the connector for that arm..since the wiper system IS NOT designed to wisk snow off the window once accumulated, this can an does happen.. even seen motors get burned out doing this..cleaning the window first will save this issue and the equiptment. need to acess this arm<take off the vented peice below the windshield and everything should be visible there..repost findings

Worn & or loose linkage

Remove the nut on the wiper motor arm to
the wiper linkage & push the wipers to where
you want them

The wiper arm can be removed and re-positioned for proper travel.

THE WASHER NOZZLES COULD BE STOPPED UP.USE SMALL PAPER CLIP TO CLEAN OUT ALL NOZZLES HOLES SEE WHAT HAPPEN.

when the wipers are off make sure the driver and passenger wipers are at same level on windshield
you can adjust them so they don't go off the edge or hit the bottom.
if they are hitting off the edge and hitting the bottom as well you need to check the linkage since it may be worn out.

on the drivers side under the dash on the firewall is a fuse panel. #23 5amp is the fuse for the wiper

wiper system. if you have a taurus station wagon #19 15amp is for the rear wiper.

under the hood on the drivers side front by the battery is a power distribution panel #28

is the wiper relay. good luck!

wiper gears may be broken, got to junk yard and buy motor and gear assembly for windshield wipers, should only take an hour to change out.

Hi check if the nut is is tight on the wiper handle to the linkage and also check that it did not strip before tightening good luck